D-Link AirPlus DI-614+ Manual page 27

Using the Configuration Menu
Advanced > Filters > IP Filter
Use IP (Internet Protocol) filters to allow or deny computers access to the Internet based
on their IP address.
Enabled or Disabled
IP Address
Port Range
Protocol Type
Schedule
Click Enabled to apply the filter policy or click Disabled to
enter an inactive filter policy. (You can reactivate the policy
later.)
Enter the IP address range of the computers that you want the
policy to apply to. If it is only a single computer that you want
the policy applied to, then enter the IP address of the computer
in the Start Source IP and leave the End Source IP blank.
Enter in the port range of the TCP/UDP ports that you want the
policy to apply to. If it is only a single port that you want the
policy applied to, then enter the port number in the Start Port
field and leave the End Port field blank. If you want to use all the
ports, you can leave the port range empty.
Select the protocol type to allow or deny certain types of IP
addresses.
Select Always, or choose From and enter the time period dur-
ing which the IP filter policy will be in effect.
27