Projection Display Operation - Panasonic PT 56DLX76 Operating Instructions Manual

Projection Display operation

Selecting Input Mode
1
Press to display the Input select
menu.
• Pressing TV/VIDEO while viewing PC
input will place unit directly into TV
input mode.
2
Press corresponding NUMBER
keys on the Remote Control to
select the input of your choice.
Or
Press to select the input of your
choice, then press "OK".
• If, during selection, no action is
taken for several seconds, the Input
selection menu is exited and the
current input is automatically selected.
Signal of source connected to
Component 1
COMPONENT VIDEO INPUT 1 is displayed.
Signal of source connected to
Component 2
COMPONENT VIDEO INPUT 2 is displayed.
Signal of source connected to HDMI IN 1 is
HDMI 1
displayed.
Signal of source connected to HDMI IN 2 is
HDMI 2
displayed.
Signal of source connected to INPUT 1 is
Video 1
displayed.
Signal of source connected to INPUT 2 is
Video 2
displayed.
Signal of source connected to INPUT 3 is
Video 3
displayed.
Signal of source connected to PC IN is
PC
displayed.
Note:
• If SKIP is set as the Input Label setting, the mode will not be
changed. (p. 65)
Card input mode (Photo Viewer) is selected.
Press to display Photo Viewer
mode.
Photo (Photo Signal of source connected to CARD SLOT
Viewer) is displayed.
Rapid Tuning
Switches between the current and last channel or input
modes.
Press to switch to previously
viewed channel or input modes.
Note:
• When Photo Viewer (p. 54) or Split screen (p. 42) is used,
Rapid Tuning is not available.
Input select
[1] TV
[2] Component 1
[3] Component 2
[4] HDMI 1
[5] HDMI 2
[6] Video 1
[7] Video 2
[8] Video 3
[9] PC
37