Panasonic PT-D12000 Operating Instructions

Additions and Corrections to the Operating Instructions
Installation in a downward vertical position
■
When installing the projector in a downward vertical position, please ensure to attach the supplied fi ttings to all lamp units.
Without the fi ttings, the lamp life may be shortened.
When installing the projector other than in a downward vertical position, remove the fi ttings.
1. Range of the downward vertical position
Downward vertical position range:
45° forward and backward from the
position perpendicular to the ceiling.
2. How to attach the fi tting to the lamp unit
Remove the lamp unit from the projector, following the "Procedure of lamp unit replacement" (Page 115) of
A
the Operating Instructions.
Insert the fi tting into the gap between the plastic holder and the wire mesh as shown in the fi gure below.
B
∗
Leave no gap between the fi tting and the wire mesh.
Install the lamp unit into the projector, following the "Procedure of lamp unit replacement" (Page 115) of
C
the Operating Instructions.
Changes in the table in page 21 of the Operating Instructions
■
Keystone correction only
Vertical
Keystone
Lens
Correction
Angle
α
ET-D75LE1 40
±
ET-D75LE2 40
±
ET-D75LE3 40
±
ET-D75LE4 40
±
ET-D75LE5 22
±
ET-D75LE6 28
±
ET-D75LE8 40
±
∗
For DZ12000, the above value changes apply.
PT-D12000/PT-DZ12000 Operating Instructions
When using arc and keystone correction together
Horizontal Vertical
Keystone Keystone
Correction Correction
(°) Angle (°) Angle (°)
β α
15 5
± ±
15 5
± ±
15 10
± ±
15 10
± ±
15 5
± ±
10 5
± ±
15 10
± ±
Insert fi tting between plastic
holder and wire mesh.
Horizontal
R2/L2
Keystone
minimum minimum
Correction
value
Angle (°)
β
5 1.6
±
5 1.2
±
10 0.8
±
15 0.6
±
5 3.0
±
5 2.4
±
15 0.4
±
Fitting
Plastic holder
Arc correction only
R3/L3 R2/L2
R3/L3 minimum value
minimum
value value
D12000
3.2 0.8
2.4 0.6
1.6 0.4
1.0 0.3
6.0 1.5 3.0
4.8 1.2 2.4
0.8 0.2
DZ12000
1.6
1.2
0.8
0.5
∗
4.3
∗
2.6
0.4
P0908-0A