Panasonic PT-50LCZ70 Operating Instruction page 7

< Side view > < Side view >
30º 30º
30º 30º
At least At least
1.8 m (PT-50LCZ70/PT-50LCZ7/PT-50LCZ70-K) / 1.8 m (PT-50LCZ70/PT-50LCZ7/PT-50LCZ70-K) /
2.0 m (PT-56LCZ70/PT-56LCZ7/PT-56LCZ70-K) / 2.0 m (PT-56LCZ70/PT-56LCZ7/PT-56LCZ70-K) /
2.2 m (PT-61LCZ70/PT-61LCZ7/PT-61LCZ70-K). 2.2 m (PT-61LCZ70/PT-61LCZ7/PT-61LCZ70-K).
Remote Control Battery Installation
Requires two AA batteries (supplied).
1.
While pressing in on the catch, open cover in
direction of arrow.
2
. Install batteries in the battery compartment.
• Battery polarity (+) and (-) must match the markings
inside the compartment.
Two AA size Two AA size
3.
Press cover until it snaps shut.
CAUTION CAUTION
Incorrect battery installation can cause the batteries to
leak, leading to personal injury and/or damage to the
Remote Control.
Observe the following precautions:
1. Always replace batteries with a pair of new ones.
2. Do not combine a new battery with an old one.
3. Do not mix battery types (example: "Zinc Carbon"
with "Alkaline").
4. Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries.
5. Battery replacement is necessary when the Remote
Control acts sporadically or stops operating the
Projection Display set.
Helpful Hints: Helpful Hints:
(1) Frequent Remote Control users choose (1) Frequent Remote Control users choose
long-lasting Alkaline batteries as replacements. long-lasting Alkaline batteries as replacements.
(2) Whenever batteries are removed, you may need (2) Whenever batteries are removed, you may need
to reset Remote Control infrared codes. to reset Remote Control infrared codes.
We suggest making a note of the codes on page 56 We suggest making a note of the codes on page 56
prior to setting up the remote. prior to setting up the remote.
Reset All Memory Functions
Use when moving unit to a new location, or when First
Time Setup needs to be done over.
Press together the VOL- button Press together the VOL- button
on the unit and MENU button on on the unit and MENU button on
the Remote Control for more than the Remote Control for more than
3 seconds. 3 seconds.
After the above message indication After the above message indication
disappeared, unplug the unit then disappeared, unplug the unit then
plug it back in and turn power ON. plug it back in and turn power ON.
Note
• When using "EZ Sync™ "HDAVI Control™"", with the device
connected, set "EZ Sync" first to "Off" and then "On" using the
Setup Menu. (p. 52-53)
Selfcheck Selfcheck Selfcheck Selfcheck
Selfcheck in progress. Selfcheck in progress. Selfcheck in progress. Selfcheck in progress.
Please refrain from any Please refrain from any Please refrain from any Please refrain from any
activity. Do not turn off activity. Do not turn off activity. Do not turn off activity. Do not turn off
or unplug the TV. or unplug the TV. or unplug the TV. or unplug the TV.
7