Panasonic NETWORK CAMERA WV-NW502S Installation Manual page 31

v
Connect a LAN cable (category 5 or better) to the network cable.
b
Connect the power cable.
Important:
• The power supply of 12 V DC shall be insulated against 120 V AC.
• When using 12 V DC power supply
Connect the output cable of the AC adapter (option) to the 2P power cable.
• When using PoE (IEEE802.3af compliant)
Connect an Ethernet cable (category 5 or better) between a PoE device (such as a hub) and
the network connector cable of the camera.
Important:
• Use all 4 pairs (8 pins) of the LAN cable.
• The maximum cable length is 100 m {328'}.
• Make sure that the PoE device in use is compliant with IEEE802.3af standard.
• When connecting both the 12 V DC power supply and the PoE device for power supply,
PoE will be used for power supply.
• When disconnecting the LAN cable once, reconnect the cable after about 2 seconds.
When the cable is quickly connected, the power may not be supplied from the PoE device.
31