Troubleshooting - Yamaha YSP-3000 Reference Manual

Refer to the following charts when the status messages appear during your iPod or XM Satellite Radio operations on this
unit. If you experience a problem that is not listed below, or if the instruction below does not help, set this unit to the
standby mode, disconnect the power supply cable, and contact the nearest authorized Yamaha dealer or service center.
iPod
Note
In case of a transmission error with no status message appearing in the front panel display and in the OSD, check the connection
between your iPod and this unit.
Status message
Loading...
This unit is in the middle of recognizing
the connection with your iPod.
This unit is in the middle of acquiring the
song lists from your iPod.
Connect error
There is a problem with the signal path
from your iPod to this unit.
Unknown iPod
Your iPod is not supported by this unit.
iPod connected
The connection between your iPod and
this unit is completed.
Disconnected
Your iPod is removed from the Yamaha
iPod universal dock.
Unable to play
This unit cannot play back the files stored
on your iPod.
XM Satellite Radio (U.S.A. and Canada models only)
Status message
CHECK ANTENNA
XM Mini-Tuner and Home Dock are not
connected to the XM jack of this unit or
not working properly.
UPDATING
The XM user encryption code is being
updated.
NO SIGNAL
The signal is too weak.
LOADING
It takes longer than four seconds to decode
audio or text data.
OFF AIR
The currently selected XM channel is not
broadcasting signals.
<XM> - - -
The Channel Station ID (SID) is no longer
available.
- - - / - - -
No artist name or song title is available.
<CAT> - - -
No channel is available for the selected
category.

Troubleshooting

Cause
Turn off this unit and reconnect the Yamaha iPod
universal dock to the DOCK terminal of this unit.
Try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, and iPod
mini are supported.
Set your iPod back in the Yamaha iPod universal
dock.
Check the playability of the files stored on your iPod.
Store other playable music files on your iPod.
Cause
Check XM Mini-Tuner and Home Dock connections
and adjust the orientation for the best reception level.
Wait until the encryption code is updated.
Adjust the orientation of the indoor antenna of Home
Dock for the best reception level.
Wait until the decoding process is finished.
Check the channel number again or select another
XM channel.
Select another channel category by pressing
CAT/A-E
TROUBLESHOOTING
Remedy
Remedy
repeatedly.
See
page
2
—
—
2
—
—
See
page
5
—
5
—
—
7
11
En