Panasonic DMR-E85H Operating Instructions Manual page 10

1
STEP Connection
Connecting a digital receiver or decoder
≥Decoder here means the device used to decode scrambled broadcasts (Pay TV).
≥Change the "AV2 Input" and "AV2 Connection" settings in the SETUP menu to match the connected equipment (➡page 43) after tuning is
completed (➡page 11, 12).
AV OUT
This unit's
rear panel
Connecting an amplifier or system component
∫ To enjoy multi-channel surround sound on
DVD-Video
Connect an amplifier with Dolby Digital, DTS and MPEG decoders
using an optical digital audio cable and change the settings in
"Digital Audio Output" (➡page 42) after tuning is completed
(➡ page 11, 12).
≥You cannot use DTS Digital Surround decoders not suited to
DVD.
≥Even if using this connection, output will be only 2 channels when
playing DVD-Audio.
Optical digital audio cable
Do not bend this cable sharply.
Insert fully, with this side facing up.
AC IN
This unit's rear panel
RQT7458
10
Digital receiver or decoder's
rear panel
21-pin Scart lead
Y
RF IN
P
B
AV1 (TV)
P
R
AV2 (DECODER/EXT)
COMPONENT
RF OUT
VIDEO OUT
(PROGRESSIVE/
INTERLACE)
Amplifier's rear panel
OPTICAL IN
OPTICAL
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
∫ Connection to a stereo amplifier
R - AUDIO -
R - AUDIO -
This unit's rear panel
Do not place the unit on
amplifiers or equipment
that may become hot.
The heat can damage the unit.
Amplifier's rear panel
AUDIO IN
R L
Red White
Audio cable
Red White
R - AUDIO - L VIDEO S-VIDEO
OPTICAL
VIDEO S-VIDEO
DIGITAL AUDIO OUT R - AUDIO - L
(PCM/BITSTREAM)