Installing The Appliance; Installation Instructions - Panasonic HL-DW165B Operating And Installation Instructions

Installing the Appliance

Electrical Connection
Check that the mains voltage corresponds to that indicated on the rating plate fixed
■
to the inside of the appliance. This data must correspond in order to avoid the risk
of damage to the appliance.
Check that the domestic power supply guarantees adequate earthing.
■
When the drawer is connected to the mains power supply, the socket and On/Off
■
switch should still be easily accessible.
The appliance must only be connected with the power cable provided.
■
Make sure that the power cable has been properly inserted into the unit's socket.
■
DO NOT use multi-plug adaptors, power strips or extension leads. There is a risk of
■
fire in the event of overloading.
Installation
There must be no rear wall connected to appliance housing.
■
There must be a gap of at least 45 mm between the wall and the back of the unit.
■
The ventilation slots and air intake points must not be covered. To ensure that
■
they remain uncovered also observe the installation instructions of any appliance
installed above the drawer.
Align the appliance flush with the units and screw it in place ensuring that the cable
■
does not become trapped or bent.
NOTE
■
■
14
EN
Ensure that the connector lead does not become trapped or bent.
After installation the connector lead must not be in contact with the
back or the base of the appliance.