Table of Contents
Advertisement
Available languages
Available languages
Display (LED) Status
Anode
Service
Fast Heating
On
Flashing
Off
On
Flashing
Off
On
Flashing
Off
On
Flashing
Off
On
Flashing
Off
On
Flashing
Off
On
Flashing
Off
Off
Flashing
Off
Off
Flashing
Flashing
(*) the third LED indicates whether or not the off-peak contact was correctly installed.
Third LED "on" if off-peak contact on.
Third LED "off" if off-peak contact out.
If the third LED is off during the off-peak period, the fault lies in the installation of the off-peak contacts.
When installing the device without off-peak contact, the third LED is always on.
Note
In an "error condition", the device is out of order.
In the case of an "anode fault" or a "potentiometer fault", the device can be manually activated for a heating cycle by press-
ing the "fast-heating" button
at the installed power for single-power and boiler mode connections, for double-power connections it heats according to the
basic load of the connection, at 1kW, 2kW or 3kW.
If the fault could not be remedied, please contact the customer service operators.
Note
When the device is full with water and functions normally (there are no faults apparent), the device cannot be separated from
the mains voltage for long periods of time, otherwise the external power source anode stops functioning and the device rusts
through. For complaints of this nature, the warranty and guarantee do not apply.
After the assembly, please present the user with the instructions for use and explain the device to them.
Heat content display
indicators (LED)
1
2
3
4
5
6
See
On
On
-
On
On
below
(*)
See
On
-
-
-
On
below
(*)
See
below
On
-
-
On
(*)
See
On
-
below
On
-
(*)
See
On
On
On
-
below
(*)
See
On
-
-
-
below
(*)
On
On
See
-
-
below
(*)
See
-
-
On
-
below
(*)
See
-
-
-
-
below
(*)
. In this case the device heats until a water temperature of 40°C is reached. The device heats
Cause / Fault
Internal
Electronic board locked, wait 15mins and
electronic
then reset
failure
The reservoir
Turn the device off, check the cause of the water
has heated
shortage (leakage, faulty water connection).
without water
If the problem remains contact technician
Water
temperature
Reset, wait until the reservoir has cooled.
-
in reservoir
If the problem remains please contact technician
too hot
Internal
-
electronic
Reset, if the problem remains please contact
failure
technician
Internal
Reset, if the problem remains please contact
-
electronic
technician
failure
Temperature
Reset, if the problem remains please contact
-
sensor fault
technician
Temperature
Reset, if the problem remains please contact
-
fault between
technician
heating/sensor
Anode fault
Check that the reservoir is filled. If the problem
-
remains please contact technician
-
Temperature
Reset not possible, please contact technician.
selector fault
Solution
Who
Technician
Technician
Technician
Technician
Technician
Technician
Technician
Technician
Technician
17
Advertisement
Table of Contents
