Connections/Initial Setup (Ready To Play) - Panasonic PV C1343 Operating Instructions Manual

Connections/Initial Setup
Please make all cable or antenna connections before power on.
Connecting
For ANT./Cable
Connect the cable from Antenna/Cable
to the VHF/UHF terminal on the unit.
For DSS/Cable Box
Connect the OUT jack on your cable
box to the VHF/UHF terminal on the unit
with a RF cable.
WARNING:
Overtightening "Nut type" RF coaxial cables
may damage jacks. Finger tighten only.
Initial Setup (Ready to Play)
Press COMBO on the remote for Combo mode.
Plug the unit power cord into AC wall
1
outlet.
Press POWER on the remote or unit.
2
The unit comes on and auto channel and
clock set starts.
• If you use a cable box, turn
it on and set it to the Public
Broadcasting Service (PBS)
channel in your time zone.
If you use a DSS receiver, it
must be turned
Settings are made automatically. When
3
setup is done, this screen appears.
8 8
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
CH AUTO SET PROCEEDING
off.
AUTO CLOCK SET
PROCEEDING
CANCEL : STOP
2 / 6 / 2003 THU 12 : 00PM
SETT I NG : CH 1 0
AUTO CLOCK SET
COMPLETED
UNIT (rear view)
VHF/UHF
UNIT (rear view)
VHF/UHF
If AUTO CLOCK SET IS INCOMPLETE screen
appears, set the clock using
SET procedure on next page.
Notes
• Function buttons are inoperative during Initial
Setup.
• To remove a cassette during Auto Set, press
EJECT twice on the remote or STOP twice on
the unit. In this case, settings must be made
manually. (See page 10.)
• Depending on conditions, Auto Clock Set may
DST : ON
take longer than 30 minutes. If so, press STOP
to stop setup and perform settings manually.
(See page 10.)
(Ready to Play)
VHF/UHF
IN from
ANT./CABLE
Cable TV
Converter Box
VHF/UHF
MANUAL CLOCK
AUTO CLOCK SET
IS INCOMPLETE
PLEASE SET CLOCK BY
PRESSING ACTION KEY
IN from
ANT./CABLE