Safety Warnings - Bosch GBR 14 CA Professional Original Instructions Manual

16 | English
4) Power tool use and care
a) Do not force the power tool. Use the cor-
rect power tool for your application. The
correct power tool will do the job better
and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch
does not turn it on and off. Any power
tool that cannot be controlled with the
switch is dangerous and must be re-
paired.
c) Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any adjust-
ments, changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out of the reach of
children and do not allow persons un-
familiar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for misalign-
ment or binding of moving parts, break-
age of parts and any other condition that
may affect the power tool's operation. If
damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g) Use the power tool, accessories and tool
bits etc. in accordance with these instruc-
tions, taking into account the working
conditions and the work to be performed.
Use of the power tool for operations differ-
ent from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qual-
ified repair person using only identical
replacement parts. This will ensure that
the safety of the power tool is maintained.
3 609 929 B58 | (17.1.08)
Machine-specific

Safety Warnings

This power tool is to be used as a grinder.
Observe all safety warnings, instructions,
illustrations and specifications provided
with this power tool. Failure to follow all in-
structions listed below may result in electric
shock, fire and/or serious injury.
This power tool is not suitable for sanding
with sanding discs, working with wire
brushs, polishing and cut-off grinding.
Operations for which the power tool is not
designed may create a hazard and cause
personal injury.
Do not use accessories which are not spe-
cifically designed and recommended by the
tool manufacturer. Just because the acces-
sory can be attached to your power tool, it
does not assure safe operation.
The rated speed of the accessory must be at
least equal to the maximum speed marked
on the power tool. Accessories running fast-
er than their rated speed can break and fly
apart.
The outside diameter of the accessory must
correspond with the dimension details of
your power tool. Incorrectly sized accesso-
ries cannot be adequately guarded or con-
trolled.
Diamand cup wheels and flanges must
properly fit the grinding spindle of your
power tool. Accessories that do not exactly
fit on the grinding spindle of the power tool
will run out of balance, vibrate excessively
and may cause loss of control.
Do not use a damaged accessory. Before
each use, inspect diamond cup wheels for
chips and cracks, wear or excessive wear. If
power tool or accessory is dropped, inspect
for damage or install an undamaged acces-
sory. After inspecting and installing an ac-
cessory, position yourself and bystanders
away from the plane of the rotating acces-
sory and run the power tool at maximum
no-load speed for one minute. Damaged
accessories will normally break apart during
this test time.
Bosch Power Tools