Yamaha BRX-610 Owner's Manual page 47

Refer to the table below when this unit does not function properly. If the problem you are experiencing is not listed below
or if the instruction below does not help, turn off this unit, disconnect the power cable, and contact the nearest authorized
Yamaha dealer or service center.
No power.
Press _ on the front panel to turn on the power. 5
This unit fails to turn The power cable is not connected or the Connect the power cable firmly. 16
on or enters standby plug is not completely inserted.
mode soon after the
power is turned on. This unit has been exposed to a strong Set this unit to standby mode, discounect the power --
external electric shock (such as lightning cable, plug it back in alter 30 seconds and then use it
This unit does not or strong static electricity), normally.
operate properly.
This unit needs to be restarted.
Press and hold (_) on the front panel for around
5 5
seconds to restart this unit. To completely restart,
unplug the power cable from the AC outlet for 5 to
10 seconds, plug the power cable to the AC outlet
again, and then turn on this unit.
The disc cannot be The Initial Wizard is not set. Set the Initial Wizard when you turn this unit on for 17
played back. the first time alter purchase or upgrade.
No sound.
No appropriate input source has been Select an appropriate input source with INPUT on 5
selected, the front panel (or the Input select buttons on the
remote control).
Speaker connections are not secure. Secure the connections. 11
The mute flmction is on. Cancel the mute flmction. 7
The volume is turned down. Turn up the volume. 7
Signals this unit cannot reproduce are Play a source whose signals can be reproduced by 3
being input from a source component, this unit.
such as a CD-ROM.
[HDMI Control] is set to ]Off]. When connecting ARC (Audio Return Channel) 36
supported TV and this unit using an HDMI cable
only, set [HDMI Control] to [On].
Audio devices are connected to the There is no dedicated digital audio output terminal --
DIGITAL IN jacks of the unit. on the unit. The audio signals input to the DIGITAL
IN jacks cannot be output from this unit to the TV.
No sound from the [HDMI] t_r audio output in SETUP menu Set [HDMI] to [Off]. 40
speakers,
is not set to [Off].
No sound or too The output level of the channel is low. Increase the output level of the channel. 40
small sound from a
specific channel.
Speaker setting is inappropriate. Adjust speakers by setting [Configuration] under 40
[Speaker Setting] in SETUP menu.
43 En