Panasonic DMP-BD80 Operating Instructions Manual page 15

Setting the connection speed
When the connection test results in "Fail" after the IP and DNS-IP
addresses are assigned, perform the following settings.
After performing steps 1–3 (
4 Press [3, 4] to select "Connection Speed
Auto-Config" and press [2, 1] to select
"Off".
5 Press [3, 4] to select "Connection Speed
Setting" and press [2, 1] to select a
connection speed.
≥Select a connection speed in accordance with the environment
of the network connected.
≥When the settings are changed, the network connection may be
disabled depending on the device.
Testing of "Proxy Server Settings"
Always test the connection when new "Proxy Server Settings"
have been made.
1 Press [SETUP].
2 Press [3, 4] to select "Network Settings"
and press [OK].
3 Press [3, 4] to select "Proxy Server
Settings" and press [OK].
4 Press [3, 4] to select "Connection Test" and
press [OK].
Proxy Server Settings
Initialize
Proxy Address
Proxy Port Number
Connection Test
OK
RETURN
"Testing...":The test is in progress.
"Pass": The connection is completed.
Press [RETURN] to exit.
"Fail": Please check the connection and settings.
14)
0
----
Setting the proxy server
In most cases, default settings can normally be used without
making any changes.
Please use this setting when instructed to by your Internet
service provider.
After performing steps 1–3 (
4 Press [3, 4] to select "Proxy Address" and
press [OK].
≥The text entry screen is displayed.
Text field: shows the text you have entered
Proxy Address
_
1 1 2 3 4 5 6 7 8 9 0
2 a b c
A B C
3 D E F d e f
4 G H I g h i
Delete 5 j k l < > @
J K L
m n o [
6 M N O
Finish
7 P Q R S p q r s
8 t u v
T U V
9 W X Y Z w x y z
0 " ' :
. , ? !
Space
OK
0 -- 9
RETURN
5 Press [3, 4, 2, 1] to select a character and
press [OK].
Repeat this step to enter other characters.
≥Press [;] to delete.
6 Press [∫] when you complete the entry.
7 Press [3, 4] to select "Proxy Port Number"
and press [OK].
8 Enter numbers with the numbered buttons
and press [OK].
Proxy Port Number
Input HTTP Proxy server port number and
press [OK]. The character below can be
deleted with [CANCEL]. The number will be
set to "0" if all characters are deleted and
[OK] is pressed.
0
0 - 9 Num ber
9 Press [2, 1] to select "Yes" and press [OK].
≥The specified ports may be blocked and not be able to be
used depending on the network environment.
In order to restore the default settings
TIPS
After performing steps 1–3 (
1) Press [3, 4] to select "Initialize" and press [OK].
2) Press [2, 1] to select "Yes" and press [OK].
Using the numbered buttons to enter characters
e.g., entering the letter "F"
1) Press [3] to move to the 3rd row.
2) Press [3] twice to highlight "F".
3) Press [OK].
left)
+ - *
/ = %
# $ &
] _
( )
~
{ }
\ I
; ` ^
left)
RQT9401
15