D-Link DSN-4100 Quick Installation Manual page 3

4. Install the Enclosure and the Hard Drive
The DSN-4100/DSN-4200 is a full iSCSI storage system, supporting up to 80 3½ inch SAS or SATA hard
disks drives. The Enclosure Status and Drive Status LED's are on the front of the unit. The two Power
switches, Reset button, Mute Audio Alarm button, network data ports, and port speed and activity LED's
are on the rear panel.
To install the hard drives into the drive carriers:
A. Remove each empty drive carrier from the enclosure by sliding the latch toward the left, pressing button
and pulling the latch to open the disk tray door.
Release Latch
Drive Carriers
FrontView
Management Port
Power Switches
Rear View (8-port configuration shown)
Driver Carrier
Enclosure Status LED's
iSCSI Data Ports Reset & Mute Buttons
Button
DSN-4000_Series Quick Installation Guide
SAS Expansion
Port
3