Troubleshooting; Guarantee Conditions - Bosch Sensixx’x DA70 EasyComfort Operating Instructions Manual

Trouble shooting
Problem
The iron does not
heat up.
Water drips out of the
soleplate when using
the "shot of steam"
function.
Steam does not come
out.
Excessive dripping or
steaming.
Smoke comes out
when connecting the
iron for the first time.
Deposits come out
through the holes in
the soleplate (10).
If none of the above solves the problem, get in touch with
an Authorised Technical Service.

Guarantee conditions

The terms of the guarantee for this
appliance are in accordance with that
stated by our representative for the country
in which it is sold.
The details of these conditions can be
obtained from the retailer from whom the
appliance was purchased. The purchase
receipt must be presented when making
any claims against the terms of this
guarantee.
Probable cause
The "SensorSecure" function
has been activated. The iron
is set to stand-by.
You have pressed the shot of
steam button (4) repeatedly
without waiting for 5 seconds
between each press.
Steam regulator (5 ) is set to
position.
No proper closing of "clean"
button (9).
This may be caused by the
lubrication of some of the
internal parts.
Traces of lime scale are
coming out of the steam
chamber.
Solution
Grip the handle of the iron to
re-start it.
Wait 5 seconds between each
press of the shot of steam
button.
Set the steam regulator to a
higher position.
Point the iron away from the
ironing area. Actuate a few times
the "clean" button.
This is normal and will stop after
a few minutes.
Carry out a cleaning cycle (see
"Calc'nClean function" section).
11
BOS CH