Decommissioning And Treatment At End Of Life; Safety Standards; Qualified Personnel; End Of Life Treatment For Circuit-Breaker Materials - ABB SACE Emax 2 Installation, Operation And Maintenance Instructions

5 - Decommissioning and treatment at end of life

Safety standards During the early stages of the process of decommissioning and end of life treatment of Emax 2 circuit-
Qualified personnel The operations for decommissioning Emax circuit-breakers involve performing procedures that can
End of life treatment for circuit-
breaker materials
Disposal of packing materials The materials used for the packaging of Emax 2 circuit-breakers are recyclable and should be treated
104 | © 2014 ABB | 1SDH000999R0002 - L8569
breakers, observe the following safety rules:
• the closing springs, even if unloaded, must never to be taken apart
• for handling and lifting of the circuit-breakers refer to the section "Unpacking and handling" on page 10 .
HAZARD! RISK OF ELECTRIC SHOCK! Unplug or disconnect any power supply, to avoid any
potential risk of shock during removal of the circuit-breaker from the service.
WARNING! After dismantling the switchgear, the circuit-breaker must be stored in the open
position with the closing springs unloaded and with the front escutcheon plate mounted.
be performed by Trained Persons, in the electrical area (IEV 195-04-02): person adequately informed or
supervised by electrotechnical personnel to allow them to perceive the risks and to avoid the hazards
potentially created by electricity.
The materials used in the production of Emax 2 circuit-breakers are recyclable and should be treated
separately as shown in the following table:
TYPE MATERIAL
A Plastic parts
B Metal parts
C Printed circuits
D Current sensors, cables, motors, electrical windings
(1)
All the components of significant dimensions bear a mark specifying the type of material.
NOTE: refer to the national legislation in force at the time of decommissioning of the product,
in the case where it specifies end of life treatment procedures different to those indicated.
separately as shown in the following table:
NOTE: refer to the national legislation in force at the time of decommissioning of the product,
in the case where it specifies end of life treatment procedures different to those indicated.
TYPE MATERIAL
A Plastic parts
B Cardboard parts
C Wooden parts
(1)
Putting into service and maintenance | 5 - Decommissioning and treatment at end of life
ABB | SACE Emax 2