Changing The Priority Of A Member Device; Adding Physical Ports To An Irf Port - HP 12500 SERIES Configuration Manual

Step
1. Enter system view.
2. Change the member ID of
a member device.
3. Save the running
configuration.
4. Reboot the member
device.

Changing the priority of a member device

You can change the priority of a member device so it can be elected the master at the next master
election.
A member priority change can affect the master re-election result, but does not cause immediate
master re-election.
To change the priority of a member device:
Step
1. Enter system view.
2. Specify a priority for a
member of an IRF fabric.

Adding physical ports to an IRF port

An IRF port can have up to 12 physical ports. In IRF mode, you can add more physical ports to an
IRF port. This task does not affect the ongoing traffic on the IRF port.
When performing this task, follow the IRF physical port restrictions and configuration guidelines in
"MPU and IRF port
To configure IRF ports:
Step
1. Enter system view.
Command
system-view
irf member member-id renumber
new-member-id
save [ safely ] [ force ]
reboot chassis chassis-number
Command
system-view
irf member member-id priority
priority
restrictions" and "Binding physical ports to IRF
Command
system-view
22
Remarks
N/A
N/A
N/A
The chassis-number must be
the same as the member-id
specified in the irf member
member-id renumber
new-member-id command.
Remarks
N/A
The default IRF member priority
is 1.
ports."
Remarks
N/A