Advertisement
Quick Links
HP 2920-24G, 2920-48G, 2920-24G PoE+, and 2920-48G PoE+ Switches
Quick Setup Guide
For more detailed instructions and information to set up your switch, view or download the Installation and Getting Started
Guide for your switch at www.hp.com/networking/support.
1.
Unpack and check included parts.
2.
Prepare for installation. To avoid personal injury or product damage, review the "Safety Precautions" on
page 4.
3.
Power on the switch and verify that Self-Test completes normally. The switch does not contain a power switch. It
is powered on by connecting power through the AC power cord. After verification, unplug the switch.
4.
(Optional) Install Modules. On the back of the switch are slots for 10 Gbps network connectivity and for high-speed
stacking. See the switch Installation and Getting Started Guide for more information on the use of these modules and
supported stacking topologies.
HP 2920 10GbE Module
Documentation kit
■
Switch
■
Console port serial cable (DB-9 to RJ-45)
■
Accessory kit (installation hardware)
■
AC power cord
■
After Self-Test:
Power LED = On
Fault LED = Off
Test LED = Off
HP 2920 Stacking Module
1
Advertisement
Related Manuals for HP 2920-24G
Summary of Contents for HP 2920-24G
- Page 1 HP 2920-24G, 2920-48G, 2920-24G PoE+, and 2920-48G PoE+ Switches Quick Setup Guide For more detailed instructions and information to set up your switch, view or download the Installation and Getting Started Guide for your switch at www.hp.com/networking/support. Unpack and check included parts.
- Page 2 SFP transceivers supported by the switch. See “SFP Installation Notes” on page 3. Connect stacking cables. If you are stacking multiple HP 2920 switches together, then connect them into a supported stacking topology using HP 2920 Stacking Modules and stacking cables. For more information on supported stacking topologies, see the Installation and Getting Started Guide for your switch.
- Page 3 SFP transceiver, the speed and duplex settings of the switch port and the connected device must match. Otherwise, the device may not link properly — you may not get a link. For some older network devices, including some older HP devices, the default speed/duplex settings may be predefined (for example, to 1000 Mbps/Full Duplex), or otherwise set differently from the default configuration of your switch port.
-
Page 4: Safety Precautions
Ensure the air flow around the switch is not restricted. Leave at least 7.6 cm (3 inches) for cooling. For the air flow ■ direction, see the Installation and Getting Started Guide for your product, located on the HP Networking web site at www.hp.com/networking/support.