Interface Description Command - Cisco 10000 Series Configuration Manual

Interface Configuration Commands
The default is no bert pattern test. Use the no form of this command to terminate a BER test.
For more information about BER testing, refer to the
Configuration Guide
Example:
•

Interface Description Command

Use the description command to identify particulars about the interface. You can enter up 80 characters
in your controller description string using the following format:
description string
In the following example, port 6 is labeled with a description to help identify it:
Router(config)# interface 4/0/6
Router(config-if)# description "Company ABC; IP = 240.21.3.8"
The description command can also be used in controller mode (see the
Note
Command" section on page
Specifying DSU Mode
The dsu mode command configures the line card to emulate a manufacturer's proprietary multiplexing
scheme. Be sure that the remote DSU connection at the far end is connected and set up as an identical
E3 or T3 interface.
Only Cisco, Digital-Link, and Kentrox are supported on E3 interfaces.
Note
Use the dsu mode command to specify a Data Service Unit (DSU) mode for a selected interface using
the following format:
dsu mode
verilink-lowbit
[no] dsu mode
The default DSU mode is cisco. Use the no form of the command to return the DSU mode to the default
mode.
In the following example, the DSU mode is set to cisco:
Router(config)# interface serial 1/0/0
Router(config-if)# dsu mode cisco
Cisco 10000 Series Router Line Card Configuaration Guide
15-10
QRSS-2^20—pseudorandom QRSS O.151 test pattern (1,048,575 bits in length)
–
and the online
Send a BERT pseudorandom pattern of 2^20 through T3 interface 1/0/0 for 5 minutes.
Router(config)# interface serial 1/0/0
Router(config-if)# bert pattern 2^20 interval 5
15-7).
[ | |
Adtran cisco digital-link
]
Chapter 15 8-Port Unchannelized E3/T3 Line Card Configuration
Cisco IOS Interface and Hardware Component
Cisco 10000 Series Internet Router Troubleshooting
| |
kentrox larscom
Guide.
"Controller Description
| |
verilink-highbit
OL-8834-04