Siemens hicom 150 H optiset E standard Operating Instructions Manual page 87

/DEHOLQJ/#'RFXPHQWDWLRQ#DQG#$FFHVVRULHV
/DEHOLQJ#.H\#)LHOGV
Key labeling sheets containing pre-cut cards are supplied with each tele-
phone and key module in an accessory pack. These cards can be used on
both sides, and are inserted into the telephone.
If you are using the "dual key assignment" function (Æ page 48), use
the back of the large card for labeling or assigning the two levels.
Use the plastic foil with the narrow strips as a protective cover.
$WWDFKLQJ#D#6WDWLRQ#1XPEHU#/DEHO
A sheet with station number labels is supplied with each telephone.
Fill out the label (fire, police, your own station number) and punch it out.
Lift the handset and attach the label in the recess of the telephone.
8VLQJ#WKH#.H\#/DEHOLQJ#3URJUDP
System Support can use the WINTASBE labeling program (order number
P31003-E80-T101-∗-19) to print the names and functions on the labeling
cards of all optiset E telephones. For many optiset E telephones, this can
be done on a perforated A4 sheet (order number A31003-E80-T100-∗-19)
containing all labeling cards.
/DEHOLQJ/#'RFXPHQWDWLRQ#DQG#$FFHVVRULHV
To label the fixed function keys
(Æ page 3), punch out the small
preprinted labeling card. Insert the
card and cover it with the plastic foil
supplied (matt side up), as shown in
the drawing.
Use one large card for labeling the
programmable keys (Æ page 3).
Punch out the card, write down the
stored functions and/or station
numbers (in the white area), insert
it, and cover it with the plastic foil
supplied (matt side up), as shown in
the drawing.
;: