Advertisement
Available languages
Available languages
It is important
for the ice maker to be level in order to work
properly. Depending upon where you install the ice maker, you
may need to make several adjustments to level it. You may also
use the leveling legs to lower the height of the ice maker for
undercounter
installations.
Tools Needed
Gather the required tools and parts before starting installation.
•
9" level
•
Adjustable
wrench
NOTE: It is easier to adjust the leveling legs if you have another
person to assist you.
1. Move the ice maker to its final location.
2.
3.
4.
NOTE: If this is a built-in installation,
move the ice maker as
close as possible to the final location.
Place the level on top of the product to see whether the ice
maker is level from front to back and side to side.
Push up on the top front
of the ice maker,
and then
locate
the leveling
screws that are on the bottom
front of the ice
maker.
Using an adjustable
wrench,
change
the height
of the legs
as follows:
•
Turn the leveling
leg to the right
to lower
that side of the
ice maker.
•
Turn the leveling
leg to the left to raise that side of the
ice maker.
NOTE:
The ice maker
should
not wobble.
Use shims to add
stability
when needed.
5. Push up on the top rear of the ice maker and locate the
leveling legs that are on the bottom rear of the ice maker.
6. Follow the instructions in Step 4 to change the height of the
legs.
7. Use the level to recheck the ice maker to see that it is even
from front to back and side to side. If the ice maker is not
level, repeat steps 2 to 5. If the ice maker is level, go to the
"Connect Water
Supply" section.
Do not use with water that is microbiologically
unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Install the Water
Filter
.
2.
Locate
the accessory
packet
in the ice maker
and remove
the water
filter.
Take the water filter out of its packaging
and remove the
cover from the O-rings. Be sure the O-rings are still in place
after the cover is removed.
A
B
D
C
3.
A. Cover
C. A/ignment
/>in
B. O-rings
D. A/ignment
arrow
The water filter compartment
is located in the right-hand
side of the ice maker control panel.
13
Advertisement
