Table of Contents
Advertisement
2 Enter the desired number of copies and confirm
with the OK button.
3 Choose the paper tray AUTOMATIC or MANUAL
with the buttons
button.
Copying in ID Card mode is only
possible on A4 (original document
size < A5) or Letter (original
Important
document size < Statement) paper
size. Make sure that the selected
paper tray uses the correct paper
size.
4 Choose the copying option ID CARD with the
buttons
or
and confirm with the OK button.
5 Choose the resolution depending on the desired
printing quality AUTO, TEXT, QUALITY TEXT or
PHOTO with the buttons
the OK button. For optimal results with ID
documents, select the PHOTO resolution.
6 Adjust the contrast level with the buttons
then confirm with the OK button.
7 Adjust the desired brightness level with the buttons
or
, then confirm with the OK button.
8 Choose the paper type NORMAL, THICK with the
buttons
or
, then confirm with the OK button.
The LCD screen displays the following message:
PUT ID CARD
THEN OK
9 Place your identity card or any other official
document against the glass of the flatbed scanner,
as shown below:
10 Press the OK button.
The document is scanned then the LCD screen
displays the following message:
TURN UP DOC
THEN OK
11 Turn your document over then confirm with the
OK button.
The machine prints out a copy of your document.
or
, then confirm with the OK
or
, then confirm with
Special setup for the copying
Setups done through this menu become the device
default setups after you confirm.
Important
Resolution setup
The RESOLUTION parameter allows you to setup the
photocopy resolution.
841 - ADVANCED FCT/COPY/RESOLUTION
1 Press
, enter 841 using the keypad.
2 Choose the resolution with the buttons
according to the following table:
or
,
Parameter
AUTO
Low resolution.
Standard resolution for
TEXT
documents containing text and
graphics.
QUALITY
Optimal resolution for
TEXT
documents containing text.
Optimal resolution for
PHOTO
documents containing
photographies.
3 Confirm your choice by pressing the OK button.
4 Quit this menu by pressing the
Note
Zoom setup
The ZOOM parameter allows you to reduce or enlarge an
area of a document by choosing the origin and the zoom
level to apply to the document, from 25 to 400 %.
842 - ADVANCED FCT/COPY/ZOOMING
1 Press
, enter 842 using the keypad.
2 Enter
the
alphanumerical
predefined values with the buttons
3 Confirm your choice by pressing the OK button.
4 Quit this menu by pressing the
- 19 -
When the quality of the printing is
not satisfying, you can proceed to a
calibration (see Calibrate your
scanner, page 24).
Signification
You can also change the resolution by
pressing the
button.
desired
zoom
level
keypad
or
choose
LFF6020
or
Icon
none
button.
with
the
among
and
.
button.
Advertisement
Table of Contents
