Practical Applications - Hitachi C 10FCD Instruction Manual And Safety Instructions

English
4. Securing the w orkpiece
WARNING:
5. Installing the extension wings (O ptional accessory)
Extension
Wing
Fig. 13
Extension
Wing
Lock Support
Rod
8 m m
Scre w
Base
Fig. 14
6. Stock stop for precision cutting (Stock stop is optional accessory)
Fig. 15

PRACTICAL APPLICATIONS

WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the tool
is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 16).
Line
14
Always clamp or vise to secure the workpiece to the fence; otherwise the workpiece
might be thrust from the table and cause bodily harm.
The extension wings help keep longer w orkpieces stable and in
place during the cutting operation.
(1) Insert the 8 m m scre w into the hole located on the base.
(2) Set the lock support rod under the side of the base.
(3) Then with the 8 m m scre w for the lock support rod te m porary
stop.
(4) Insert an extension wing into the tw o holes of the lock support
rod.
(5) Push an extension wing until it contact with the base.
(6) Fasten the 8 m m scre w and fix an extension wing.
CAUTION:
Extension Wing
Stock Stop
6 m m Wing Bolt
Warning Sign
When transporting or carrying the tool, do not
grasp the extension wing.
There is the danger of the extension wing slipping
out of the base. Grasp the handle (see Fig. 1)
instead of the extension wing.
The stock stop facilitates continuous precision cutting
in lengths of 10" to 16-21/32" (253 m m to 423 m m). To
install the stock stop, attach it to the extension wing with
the 6 m m wing bolt as sho w n in Fig. 15.
Warning Sign
Fig. 16
Line