Concerning Cutting Of Stainless Steel Plates; Selection Of Blades - Hitachi CJ 14DSL Handling Instructions Manual

English
(6) Insert dust collector into the rear hole of the base until the
hook catches in the notch. (Fig. 28)
(7) Press the hook to remove the dust collector.
NOTE
Wear the dust mask additionally, if available.
CONCERNING CUTTING OF STAINLESS STEEL
PLATES
CAUTION
In order to prevent blade dislodging, damage or excessive wear on the Plunger,
please make sure to have surface of the base plate attached to the work piece
while sawing.
When cutting stainless steel plates, adjust the unit as described below:
1. Adjust the speed.
Blade
No. 97
NOTE
The higher the speed is, the quicker the material is cut. But the service life of the blade will
be reduced in this case. When the speed is too low, cutting will take longer, although the
service life will be prolonged. Make adjustments as desired.
2. Set the orbital position to "0"
NOTE
When cutting use cutting fl uid (oil base cutting fl uid) to prolong the blade's service life.

SELECTION OF BLADES

Accessory blades
○
To ensure maximum operating effi ciency and results, it is very important to select the
appropriate blade best suited to the type and thickness of the material to be cut. Three
types of blades are provided as standard accessories. The blade number is engraved in
the vicinity of the mounting portion of each blade. Select appropriate blades by referring to
Table 5 on page 38.
Thickness of material
1.5 – 2.5 mm
36
Notch
Hook
Base
Rear
hole
Adapter
Dust
collector
Fig. 28
Speed
Middle speed
Nose