Configuration Menu - Sony UTX-B03HR Operating Instructions Manual

2
Press and hold the SET button until the setting starts
flashing.
3
Press the + or – button to change the setting.
4
Press the SET button to apply the setting.
Note
If no operation is performed for 5 seconds, the backlight
will turn off. Pressing any button will turn the backlight
on again.

Configuration Menu

This section describes each function and configurable
items.
Underlined entries indicate factory default settings.
Selecting group/channel (GP/CH)
The factory default setting varies depending on the
model.
For details, see "Setting the Transmit Channel" (page 8).
Note
This function can be modified in transmission stopped
mode only.
Selecting the frequency band (BAND)
Select the transmit frequency band.
Notes
• This function can be modified in transmission stopped
mode only.
• This menu is not available on Japanese and Korean
models. On these models, the frequency band cannot be
selected.
For details about the groups and channels in each
frequency band, refer to the "Frequency List" on the
CD-ROM.
Setting the transmit output level (RF
POWER)
Set the transmitted RF power to HIGH or LOW. The
transmit power level varies depending on the model.
Note
This function can be modified in transmission stopped
mode only.
Adjusting the audio input attenuation
level (ATT)
Set the audio input attenuation level in 3 dB increments to
reduce noise distortion.
The factory default setting is 9 dB.
Notes
• "---" is displayed if IN LEVEL is set to LINE, and the
attenuation level cannot be modified (fixed at 0 dB).
• If the attenuation level is set too high, the noise level
may increase. Set the level as close as possible to 0 dB
if using a lavalier microphone attached to your torso.
Setting the low-cut filter (LCF)
Set the low-cut filter to reduce noise caused by wind.
You can set the cutoff frequency to OFF/LOW/MID/
HIGH.
OFF: No filtering
LOW: 100 Hz cutoff frequency
MID: 150 Hz cutoff frequency
HIGH: 200 Hz cutoff frequency
Switching the audio input level (IN LEVEL)
Set the input level according to the audio input device.
You can switch between MIC and LINE. The factory
default setting is MIC.
Note
Do not switch this function to "MIC" when the audio
input source is an audio mixer or other line level device.
If an excessive audio level is input, it may cause noise
distortion or damage the playback/recording equipment.
Displaying the accumulated running time
(TIME)
Display the accumulated running time of the transmitter
as a guide to total usage time.
The factory default setting is 00:00. Up to 99:99 can be
displayed.
To reset the time display
1
Press and hold the SET button until the time display
starts flashing.
2
Press the – button to display "00:00 CLR" and press
the SET button.
Pressing the + button when "00:00 CLR" is displayed
causes the time display to start flashing. You can
press the SET button in this state to cancel the reset of
the accumulated running time.
Setting the menu display mode (MENU
MODE)
Set the menu display mode.
SIMPLE: Displays only the required settings.
11