Troubleshooting; Disposal - Silvercrest SKHD 1800 A1 Operating Instructions Manual

RP90873 Keramikheizlüfter LB4 Seite 9 Donnerstag, 27. Juni 2013 5:03 17
2. Select the low or high heat setting on the
function selector 1 (see "7.2 Selecting
functions" on page 8).
7.8 Fan function
1. Select the fan function
selector 1.
Fault
Appliance cannot be
switched on
Appliance switches off
automatically
Only cold air is produ-
ced
9.1 Appliance
The symbol with the crossed-
out rubbish bin on wheels
means that within the European
Union, the product must be
disposed of to a sorted rubbish
collection. This applies to the
product and all accessories which are
SKHD 1800 A1
on the function

8. Troubleshooting

Cause
Faulty fuse or wall socket
Faulty appliance
Safety switch has triggered
Thermal cut-out has triggered
Selected temperature has been
reached

9. Disposal

2. Set the temperature selector 2 to
"MAX".
7.9 Transporting the appliance
If you wish to transport the apliance, always
carry it by the lift-up carry handle 4.
Remedy
Select another wall socket
Have repairs carried out at a specialist
workshop or dispose of the appliance. You
will find the service address in "10. HOYER
Handel GmbH Warranty" on page 10.
Set the appliance upright (see "7.6 Safety
switch" on page 8)
Allow the appliance to cool down (see
"7.5 Thermal cut-out" on page 8)
Clean the appliance (see "6. Cleaning" on
page 7)
Appliance switches on again automatically
as soon as the room temperature falls
Select a higher desired temperature
marked with this symbol. Marked products
must not be disposed of via the regular
domestic waste but must be handed in to a
recycling centre for electrical or electronic
devices. Recycling helps to reduce the use of
raw materials and
environment. It is therefore imperative that
you follow the disposal
applicable in your country.
to relieve the
regulations
9