Page 1
HD-MOD BDP-LX70A_95FD Pioneer BDP-LX70A/95FD Installation Manual Please note that this modification to your player invalidates any warranty that may already exist on your player. Introduction Installing this modification is difficult. It requires soldering and the use of hot air soldering...
Page 2
HD-MOD BDP-LX70A_95FD Opening your player First make sure that your player is disconnected from the mains before you even start opening the player. If you set the unit in front of you with the display towards you there are 3 screws at the back of the player.
Page 4
HD-MOD BDP-LX70A_95FD Mainboard connections (bottom): Install the supplied Flash chip at the empty spot on the board (IC2761). Make sure you align the chip correctly; pin 1 is indicated with a dot on the chip. Make the bridge, and remove the resistor (see picture). Then solder a wire from point M and N to the corresponding point on the logic board.