Dispensing Hot Water - Whirlpool 7LIECH-SSF-WL User Manual

Dispensing Cold Water
Note: After setup, it will take up to 1 hour to get the water to its coldest temperature. During
this time, the compressor may run continuously as the refrigeration system builds the Ice Bank
as noted in the "Product Features" section.
1. Position the container you wish to fill with water securely below the cold-water tap.
• The right triangle below the cold water control indicates the location of the cold water
tap (See the "Parts & Features" section on page 5).
• The circular shapes in the drip plate help to align the flow of water. This unit dispenses
water quickly. To avoid splashes, hold the cup as close to the tap as possible.
2. Press the right control downward to start dispensing water.
3. Release the control once desired fill level is achieved.

Dispensing Hot Water

1. Hot water available 15~20 minutes after set up.
2. Red arrow and target holes in the grill indicate positioning of your container for dispensing
hot water.
3. Hold your container close to dispensing nozzle to avoid splashes.
4. To activate hot water dispensing nozzle push red lock inwards and hot button downwards.
5. To stop dispensing hot water release the button.
Replacing an Empty Bottle
WARNING
Excessive Weight Hazard
Use two or more people to move and install the
water cooler and the bottles.
Failure to do so can result in back or other injury.
Note: Replace the bottle as soon as you notice that it is empty.
1. Lift the bottle straight up to disengage it from the bottle probe.
2. Remove the tamper seal from the top of bottle cap of the fresh bottle. Do NOT remove the
plastic cap.
3. Lift the bottle and insert it onto the probe. Apply slight pressure until the plug inside the
cap pushes in and the bottle is seated. Water will begin to flow into the reservoirs, causing
air bubbles in the bottle
IMPORTANT: Do NOT Return Dispenser To Store.
If you have a question or problem, please contact 1-855-594-4755 for assistance.
Model # 7LIECH-SSF-WL: Page 8