Panasonic CF-19 series Operating Instructions Manual page 10

Regulatory Information
For UK
For your safety, please read the following text carefully.
This appliance is supplied with a molded three pin mains plug for your safety and convenience.
A 3 ampere fuse is fi tted in this plug.
Should the fuse need to be replaced please ensure that the replacement fuse has a rating of 3 ampere and that it is
approved by ASTA or BSI to BS1362.
Check for the ASTA mark
If the plug contains a removable fuse cover you must ensure that it is refi tted when the fuse is replaced.
If you lose the fuse cover the plug must not be used until a replacement cover is obtained. A replacement fuse cover
can be purchased from your local dealer.
If the fi tted molded plug is unsuitable for the socket outlet in your home then the fuse should be removed and the plug
cut off and disposed of safely.
There is a danger of severe electrical shock if the cut off plug is inserted into any 13-ampere socket.
How to replace the fuse
The location of the fuse differs according to the type of AC mains plug (fi gures A and B).
Confi rm the AC mains plug fi tted and follow the instructions below. Illustrations may differ from actual AC mains plug.
Open the fuse cover with a screwdriver and replace the fuse and close or attach the fuse cover.
Figure A Figure B
For U.S.A.
Federal Communications Commission Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the Panasonic Service Center or an experienced radio/TV technician for help.
Warning
To assure continued compliance, use only shielded interface cables when connecting to a computer or peripheral. Also, any chang-
es or modifi cations not expressly approved by the party responsible for compliance could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC RF Exposure Warning:
 This equipment is provided with PC Card slot that could be used with wireless transmitters, which will be specifi cally recom-
mended when they become available.
Other third-party wireless transmitters have not been RF exposure evaluated for use with this computer and may not comply
with FCC RF exposure requirements.
<Only for model with wireless LAN/wireless WAN/Bluetooth>
 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
 This equipment has been approved for portable operation, and does not require any minimum spacing be provided between
antennas and all person's body. If provided with wireless WAN transmitter, requires LCD side panel spacers to provide the fol-
lowing spacing between antenna located within the LCD side panel, and all person's body (excluding extremities of hands, wrist
and feet) during wireless modes of operation.
Model with MC7355 : minimum 16.7 mm
Model with other than MC7355 : minimum 1.5 cm
  This equipment may not be co-located or operated with any other antenna or transmitter.
10
or the BSI mark on the body of the fuse.
A S A
Fuse cover
8-E-1