Safety Precautions General Guide Lines When servicing, observe the original lead dress. If a short circuit is found, replace all parts which have been overheated or damaged by the short circuit. After servicing, see to it that all the protective devices such as insulation barriers, insulation papers shields are properly installed.
Prevention of Electrostatic Discharge (ESD) to Electrostatically Sensitive (ES) Devices Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called Electrostatically Sensitive (ES) Devices. Examples of typical ES devices are integrated circuits and some field-effect transistors and semiconductor "chip"...
About lead free solder (PbF) Note: Lead is listed as (Pb) in the periodic table of elements. In the information below, Pb will refer to Lead solder, and PbF will refer to Lead Free Solder. The Lead Free Solder used in our manufacturing process and discussed below is (Sn+Ag+Cu). That is Tin (Sn), Silver (Ag) and Copper (Cu) although other types are available.
Service Hints How to remove the backcover Remove the 18 fixing screws. (see Fig.5) SCREWS SCREWS Fig.5 How to remove the Pedestal assembly Lay the main unit face down. (see Fig.6) Fig.6 Remove the 4 fixing screws and the pedestal assembly. (see Fig.7) SCREWS Fig.7...
Chassis Board Layout G-BOARD P-BOARD A-BOARD K-BOARD V-BOARD Board Name Function A-Board Tuner, PC, AVSW, HQ1L, HDMI,Global Core, GENX, AV Terminal, SD Slot, Speaker out, ADV P-Board Power Supply, Main Input V-Board Remote Receiver, Bats, R/G LED G-Board Side AV Connector K-Board Main Switch Location of Lead Wiring...
Setting Inspection Voltage Confirmation Confirm the following voltages: P board Description Test point Position Normal mode Stand by mode Active stand by mode Panel 12V TP863 P2, pins 16, 17 12,0V +/- 0,35V 12V +/- 0,35V 16V_Audio TP858 P2, pins 20, 21 16V +/- 1V 16V +/- 1V SUB_9V...
Power LED blinking timing chart Subject Information of LED Flashing timing chart. Contents When abnormality has occurred the unit, the protection circuit operates and reset to the stand by mode. At this time, the defective block can be identified by number of blinking of the Power LED on the front panel of the unit. Blinking Blinking timing Contents...
Service Mode Function MPU controls the functions switching for each IICs through IIC bus in this chassis. The following setting and adjustment can be adjusted by remote control in Service Menu How to enter SERVICE While pressing (-/v) button on TV unit, press on the remote control for 3 times within 2 seconds.
SERVICE SERVICE Peaks SOFT 2.106 OPTION 1 0c Key Command ADJUST Peaks EEP 01.05.0034 OPTION 2 WB-ADJ LSI DATA 0.00.04 OPTION 3 OPTION STBY SOFT 1.01.00 Model ID • SRV-TOOL STBY EEP 1.07.00 032b1100 Press the 3/4 button to change the adjustment values or function. STBY ROMCOR 1.04.00 00000010...
Option Bytes Description OPTION1 ATP Speed Slow (1) / Fast (0) TXT Ch On (1) / Off (0) ID-1 On (1) / Off (0) Macrovision Auto Evaluation On (1) / Off (0) SRS Surround On (1) / Off (0) Teletext Top Off (1) / On (0) Equalizer Not Use...
Adjustment Method Sub-Contrast/White Balance Adjustment Instrument Name Connect to Remarks Remote controller Correlation can be also taken by LCD WB meter (Minolta CS-1000A equivalent) CA-210 or equivalent Comunication jig Computer for external control Procedure Remarks Let the panel standfor more than 3 hours at more than 20 °C.
Replacement Parts List Important Safety Notice Components Identified by mark have special characteristics important for safety. * When replacing any of these components, use only manufacturers specified parts. In case of ordering these spare parts, please always add the complete Model-Type number to your order. RTL (Retention Time Limited) Note: The marking (RTL) indicates that the Retention Time is Limited for this item.
Page 24
Cct Ref Parts Number Description Cct Ref Parts Number Description FUSES D3027 MAZ81400ML DIODE D3028 MAZ81400ML DIODE F801 K5D502BNA007 AC FUSE D3030 MAZ81400ML DIODE DIODES D3031 MAZ81400ML DIODE D801 ERZV10V621T2 VARISTOR D3032 MAZ81400ML DIODE D802 MA22F2000L DIODE D3052 MA3X704A0L DIODE MA704ATX D803 MA2J11100L DIODE...
Page 40
Cct Ref Parts Number Description Cct Ref Parts Number Description C8056 F1G1C104A116 S.M.CAP 100nF TXASX01NXA-1 AC CORD ASSY C8057 F1G1C104A116 S.M.CAP 100nF TKU0E1701 BACK COVER C8058 F1J1A106A043 S.M.CAP 10µF TTY0E0312 CABINET ASSY C8067 F1G1E103A123 S.M.CAP 10nF TUA0E2600 L CHASSIS FRAME BRACKE C8068 F1G1C104A116 S.M.CAP...
Page 41
Cct Ref Parts Number Description Cct Ref Parts Number Description CARTON TPC0E49600 CARTON DIFFERENCES FOR MODEL TX--37LX85F TOPCUS TPD0E1047 TOP CUSHION INSTRUCTION BOOKS EXPLODED VIEW TQB0E0681-1 ENGLISH A-37LX85F A P.C.B. I.C.s TXASX01NXA-1 AC CORD ASSY IC8601 X24C32LX85L EEPROM PL2 TKU0E1801 BACK COVER TERMINALS AND LINKS TUA0E3600...
Page 42
Cct Ref Parts Number Description Cct Ref Parts Number Description L5EDD9Q00004 LCD PANEL TQB0E0663W-1 SLOVAKIAN TBM0E1469-1 MODEL LABEL TQB0E0663X1 CD ROM TTX0E0007 PEDESTAL ASSY TQB0E0663Z-1 ESTONIAN TKP0E91801 POWER BUTTON BRACKET I.C.s TUA0E3400 R CHASSIS FRAME BRACKE IC8601 X24C37LX85P EEPROM PL2 TKP0E35401 TRIM PANEL TERMINALS AND LINKS...
Page 43
Cct Ref Parts Number Description Cct Ref Parts Number Description INSTRUCTION BOOKS TQB0E0567L-1 RUSSIAN TQB0E0567Y-1 UKRAINIAN I.C.s IC8601 X24CR37LX85 EEPROM PL2 TERMINALS AND LINKS A1-V1 TXJA1NUA-1 A1-V1 WIRE A5-PAN K1PY51Y00016 A5-PANEL WIRE A12-K1 TXJA12NUA A12-K1 WIRE A14-SPK TXJA14NUA-3 A14-SPK WIRE CN-A,P TXJP5NUA-1 CN101-A13/P5 WIRE...
Schematic Diagrams IMPORTANT SAFETY NOTICE Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturers' specified parts. NOTE RESISTOR All resistors are carbon ¼W resistor, unless marked otherwise. Unit of resistance is OHM (Ω) (k=1,000, M=1,000,000) CAPACITORS All capacitors are ceramic 50V unless marked otherwise.