Advertisement
Getting the PathFinder ready
1. Connect the car charger to the R710(t)/R800 cradle.
2. Connect the Mini USB cable of the PathFinder to the
Mini USB port of the R710(t)/R800 cradle.
3. After fixing the PathFinder's position on the
dashboard, switch the PathFinder and R710(t)/R800
on, then. from the main menu of R710(t)/R800, tap
Settings > PathFinder > LED
4. You will find a projection area on your windshield.
5. Clean the projection area with a clean cloth.
6. Spray a thin layer of clean water on the projection
area.
Note: T o prevent the dashboard from getting damp, DO NOT spray too much water onto the windshield and use a piece of
dry cloth to cover the dashboard.
7. Peel off the reflection film (grey) from the backside
film (achromatic).
8. Carefully paste the reflection film on the projection
area.
9. Remove the bubbles between the reflection film and
the windshield to ensure they are tightly adhered.
Using the reflection film applicator, gently move its
edge on the reflection film to remove the bubbles.
Testing.
Reflection Film Applicator
Reflection Film
Advertisement
