ORDER No. PCZ0602003CE Service Manual Colour LCD Television TX-32LXD60 TX-26LXD60 GLP21 Chassis SPECIFICATIONS (Information in brackets [ ] refers to model TX-26LXD60) Power Source: 220-240V AC, 50Hz AV3 IN S-Video IN Y:1V p-p 75Ω (4-pin) C:0,3V p-p 75Ω Power Consumption:...
Measuring network for TOUCH CURRENTS COLD WATER PIPE (EARTH GROUND) =500µF =500Ω 10kΩ APPLIANCES =500Ω 0.022µF EXPOSED METAL PARTS Resistance values in ohms (Ω) Input resistance: ≥ 1MΩ Voltmetr or oscilloscope Input capacitance: ≤ 200pF (r.m.s. or peak reading) Frequency range: 15Hz to 1Mhz and d.c.respectively NOTE –...
ABOUT LEAD FREE SOLDER (PbF) Note: Lead is listed as (Pb) in the periodic table of elements. In the information below, Pb will refer to Lead solder, and PbF will refer to Lead Free Solder. The Lead Free Solder used in our manufacturing process and discussed below is (Sn+Ag+Cu). That is Tin (Sn), Silver (Ag) and Copper (Cu) although other types are available.
SERVICE HINTS How to remove the pedestal assembly Lay the main unit face down as shown in Fig.5. Fig.5 Remove the 2 fixing screws and hinge cover as shown in Fig.6. Remove the 8 fixing screws and the pedestal assembly as shown in Fig.7.
CHASSIS BOARD LAYOUT KEY CONTROL K-BOARD P-BOARD XV-BOARD H-BOARD V-BOARD A-BOARD B-BOARD Board Name Function A-Board Main Board B-Board Tuner H-Board AV3 Terminal Key Control Key Control K-Board Mains Input, Power Switch P-Board Power Supply V-Board Remote Receiver, LED IR, Bats XV-Board IDTV Processor, D/A Converter, SETTING INSPECTION...
(-/v) button on the customer controls at the front the TV set. To exit Self Check, switch off the TV set at the power button. TX-32LXD60 TX-26LXD60 O.K. O.K. OPTION 1 O.K.
ALIGNMENT SETTINGS (The figures below are nominal and used for representative purposes only.) Set the Bass to maximum position, set the Treble to minimum position then keep pressing the INDEX button on the remote control and press the down button (-/v) on the customer controls at the front of the TV, this will place the TV into the Service Mode 1.
JK3001 TO LCD PANEL HP RIGHT HP LEFT RED/C IN G IN B IN CVBS OUT RED/C IN G IN B IN CVBS IN L IN R IN L OUT R OUT AV2 R OUT CVBS OUT CVBS IN R IN G IN B IN L IN...
Page 10
COMP VREF SIGNAL24V D851 D852 MAIN IN D853 AUD12_16 Q873 LCF´S LCF´S LCF´S...
SCHEMATIC DIAGRAMS FOR MODELS TX-32LXD60, TX-26LXD60 (GLP21 CHASSIS) IMPORTANT SAFETY NOTICE Components identified by mark have special characteristics important for safety. When replacing any of these components, use only manufacturers' specified parts. NOTE RESISTOR All resistors are carbon ¼W resistor, unless marked otherwise.
Page 61
TNPA3740 XV-BOARD XV BOARD SCHEMATIC DIAGRAM IS NOT INCLUDED, IT IS ONLY EXCHANGE UNIT.