This appliance must be connected to the main power supply by means of a circuit breaker or a switch with a contact separation of at least 3 mm in all poles.

DANGER

• FOR USE BY QUALIFIED PERSONS ONLY.

• TURN OFF MAIN POWER SUPPLY BEFORE ATTEMPTING ANY ELECTRICAL WORK. MAKE SURE ALL POWER SWITCHES ARE OFF.

FAILURE TO DO SO MAY CAUSE ELECTRIC SHOCK.

• CONNECT THE CONNECTING CABLE CORRECTLY. IF THE CONNECTING CABLE IS CONNECTED WRONGLY, ELECTRIC PARTS MAY BE

DAMAGED.

• CHECK THE EARTH WIRE THAT IT IS NOT BROKEN OR DISCONNECTED BEFORE INSTALLATION.

• DO NOT INSTALL NEAR CONCENTRATIONS OF COMBUSTIBLE GAS OR GAS VAPORS.

FAILURE TO FOLLOW THIS INSTRUCTION CAN RESULT IN FIRE OR EXPLOSION.

• TO PREVENT OVERHEATING THE INDOOR UNIT AND CAUSING A FIRE HAZARD, PLACE THE UNIT WELL AWAY (MORE THAN 2 M) FROM

HEAT SOURCES SUCH AS RADIATORS, HEATERS, FURNACE, STOVES, ETC.

• WHEN MOVING THE AIR CONDITIONER FOR INSTALLING IT IN ANOTHER PLACE AGAIN, BE VERY CAREFUL NOT TO GET THE SPECIFIED

REFRIGERANT (R32) WITH ANY OTHER GASEOUS BODY INTO THE REFRIGERATION CYCLE. IF AIR OR ANY OTHER GAS IS MIXED IN THE

REFRIGERANT, THE GAS PRESSURE IN THE REFRIGERATION CYCLE BECOMES ABNORMALLY HIGH AND IT RESULTINGLY CAUSES BURST

OF THE PIPE AND INJURIES ON PERSONS.

• IN THE EVENT THAT THE REFRIGERANT GAS LEAKS OUT OF THE PIPE DURING THE INSTALLATION WORK, IMMEDIATELY LET FRESH AIR

INTO THE ROOM. IF THE REFRIGERANT GAS IS HEATED BY FIRE OR SOMETHING ELSE, IT CAUSES GENERATION OF POISONOUS GAS.

WARNING

• Never modify this unit by removing any of the safety guards or bypassing any of the safety interlock switches.

• Do not install in a place which cannot bear the weight of the unit.

Personal injury and property damage can result if the unit falls.

• Before doing the electrical work, attach an approved plug to the power supply cord.

Also, make sure the equipment is properly earthed.

• Appliance shall be installed in accordance with national wiring regulations.

If you detect any damage, do not install the unit. Contact your dealer immediately.

• Do not use any refrigerant different from the one speciﬁ ed for complement or replacement.

Otherwise, abnormally high pressure may be generated in the refrigeration cycle, which may result in a failure or explosion of the product or an injury to your

body.

• Do not use means to accelerate the defrosting process or to clean, other than those recommended by the manufacturer.

• The appliance shall be stored in a room without continuously operating ignition sources (for example: open ﬂ ames, an operating gas appliance or an operating

electric heater).

• Be aware that refrigerants may not contain an odour.

• Do not pierce or burn as the appliance is pressurized. Do not expose the appliance to heat, ﬂ ame, sparks, or other sources or ignition. Else, it may

explode and cause injury or death.

• For R32 model, use pipes, ﬂ are nut and tools which is speciﬁ ed for R32 refrigerant. Using of existing (R22) piping, ﬂ are nut and tools may cause

abnormally high pressure in the refrigerant cycle (piping), and possibly result in explosion and injury.

• Thickness of copper pipes used R32 must be more than 0.8mm. Never use copper pipes thinner than 0.8mm.

• Do not perform ﬂ are connection inside a building or dwelling or room, when joining the heat exchanger of indoor unit with interconnection piping.

Refrigerant connection inside a building or dwelling or room must be made by brazing or welding. Joint connection of indoor unit by ﬂ aring method can

only be made at outdoor or at outside of building or dwelling or room. Flare connection may cause gas leak and ﬂ ammable atmosphere.

• After completion of installation or service, conﬁ rm there is no leakage of refrigerant gas. It may generate toxic gas when the refrigerant contacts with

ﬁ re.

• Appliance and pipe-work shall be installed, operated and stored in a room with a ﬂ oor area larger than A

How to get A

: A

= (M / (2.5 x 0.22759 x h

min

M is the refrigerant charge amount in appliance in kg. h

mounted/1.0 m for window mounted/2.2 m for ceiling mounted.

• Comply with national gas regulations.