Table of Contents
Advertisement
Operational guide
SET UNI T
SELECT
The central controller provides three control modes:
1.Unitary control mode: See Total on/Total off Unitarily Control Function .
2.Unit selection control mode:
1 The cursor flashes at
may change the flashing location of the cursor and the current
unit number (the cursor will flash even if the unit does not exist.). The
controller takes the current unit with the flashing cursor as unit selection
mode;
2 After completion of selection, parameters of mode, fan speed, temperature
and timer could be changed;
3 After setting the parameters, press CONFIRM key to send the settings
to the air conditioner and thus the unit selection control is completed.
4 After step
, directly press the ON/OFF key and CENTRAL/REMOTE
key, the requirement settings could also be transmitted to the air conditioner
and then the unit selection control is completed.
Remarks:
Within 10s if no parameter (mode, fan speed, temperature) setting keys
haven t be pressed or the CONFIRM key hasn t be pressed to send instruction
to the air conditioner, the time-out control will automatically cancel the
just made settings, and the system will automatically restore central control
and cyclic monitor status.
ON
M ODE
OFF
FAN SPEED
4
2
2
LOCK
of the current unit. Using the direction keys
13
Unit selection and group
selection control
Total on/Total off
REM OTE
TEM P
RO O M
TEM P
TI M E TI M ER
TEM P.
TI M E
2
3
CENTRAL
REM O TE
CO NFI RM
Advertisement
Table of Contents
