Setup Operations; Troubleshooting - Philips DCP850 User Manual

SETUP OPERATIONS

To maximize your playback experience, use SETUP to fine tune your settings.
Use the 3,4,1, 2 keys to highlight your selection, and press OK.
1 Press SETUP. A list of features is shown.
2 Use the 3 4 keys to highlight your selection.
When the cursor highlights these settings, press OK to:
General Setup Page select display and other options
Video Setup Page select video options
Password Setup Page select password options
Preference Page select playback preferences
Exit exit the system menu
3 Press 1 to abort current settings or go back to previous menu level.
4 Press SETUP to exit.
General Setup Page
When the cursor highlights these settings, press OK to:
TV Display select display ratio
Angle Mark select angle mark display options
OSD Lang select onscreen display language
Screen Saver select screen saver options
Last Memory select last playback memory options
Press 1 to abort current settings or go back to previous menu level

TROUBLESHOOTING

If it appears that the DVD-Video player is faulty, first consult this checklist.
It may be that something has been overlooked.
WARNING
Under no circumstances should you try to repair the set yourself as this
will invalidate the guarantee.
If a fault occurs, first check the points listed, before taking the set for
repair. If you are unable to solve a problem by following these hints,
consult your dealer or service centre.
Symptom Remedy
No power – Check if both plugs of the mains cord are
– Check if there is power at the AC outlet by
– Check if the built-in battery is drained.
– Check if car adaptor is connected appropriately.
Distorted picture – Check the disc for fingerprints and clean with
– Sometimes a small amount of picture
Completely distorted – The NTSC setting may be in the wrong
picture / no colour in
the TV screen
No sound – Check audio connections. If using a HiFi
properly connected.
plugging in another appliance.
a soft cloth, wiping from centre to edge.
distortion may appear. This is not a
malfunction.
status. Match your TV's setting with the
player's setting.
amplifier, try another sound source.
SETUP OPERATIONS
Video Setup Page
When the cursor highlights these settings, press OK to:
Quality select video quality options
R
DivX VOD get DivX ID for VOD
Press 1 to abort current settings or go back to previous menu level
Password Setup Page
When the cursor highlights these settings, press OK to:
Password change existing password (3308 by default)
Press 1 to abort current settings or go back to previous menu level
Note: Parental options are only selectable when password mode is deactivated.
Preference Page
When the cursor highlights these settings, press OK to:
Audio select audio language options
Subtitle select subtitle language options
Disc Menu select disc menu language options
Parental select parental options
Default restore factory settings
Press 1 to abort current settings or go back to previous menu level
TROUBLESHOOTING
Symptom Remedy
Disc can't be played – Ensure the disc label is upwards.
– Clean the disc.
– Check if the disc is defective by trying
The player does not – Aim the remote control directly at the
respond to the remote
control
Distorted or B/W – Use only discs formatted according to the
picture with DVD
Player does not respond – Operations are not permitted by the disc.
to all operating commands – Refer to the instructions in the disc inlay.
during playback
Player feels warm – When the player is in use for a long
Display goes dimmer when – The unit is saving power to ensure longer
AC is unplugged
This set complies with the radio interference requirements of the
European Union.
another disc.
sensor on the front of the player. Avoid all
obstacles that may interfere with the signal
path. Inspect or replace the batteries.
TV-set used (NTSC).
period of time, the surface will be heated.
This is normal.
playtime with battery. It is normal.
Adjust the brightness using the rotary
brightness control.