Auto Standby; Apply Factory Settings; Radio - Philips htl1193b User Manual

4
Select and play audio files or music on
your Bluetooth device.
• During play, if a call is coming, music
play is paused.
• If your Bluetooth device supports
AVRCP profile, on the remote control
you can press / to skip to a track,
or press to pause/resume play.
5
To exit Bluetooth, select other source.
• When your switch back to Bluetooth
mode, Bluetooth connection remains
active.
Note
•
The music streaming may be interrupted by obstacles
between the device and this product, such as wall,
metallic casing that covers the device, or other devices
nearby that operate in the same frequency.
•
If you want to connect this product with another
Bluetooth device, press and hold on the remote
control to break the current Bluetooth connection.

Auto standby

When playing media from a connected device,
this product automatically switches to standby
after 15 minutes of button inactivity and no
audio play from a connected device.

Apply factory settings

You can reset this product to the default setting
mode.
1
In mute mode, quickly press AUX two
times.
» The factory settings is restored.

Radio

Listen to FM radio on this product, and store up
to 40 radio stations.
EN
10
Note
•
Position the antenna as far as possible from TV or other
sources of radiation.
•
For optimal reception, fully extend and adjust the
position of the antenna.
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are prompted to
install the radio stations again.
Auto install radio stations
1
Press RADIO to switch to radio source.
» If you have not installed any radio
stations, the message AUTO INSTALL
(auto install) scrolls on the display
panel.
2
Press to install radio stations.
» RADIO INSTALL (radio install) scrolls
on the display panel.
» This product automatically stores radio
stations with sufficient signal strength.
• To clear all the existing radio stations,
press and hold PROGRAM for 3
seconds to reinstall the radio stations.
Select a preset radio station
1
In radio mode, display a preset number
(press ).
2
Press / to select a preset number.
Tune to a radio station
1
In radio mode, display a radio frequency
(press ).
2
Press and hold / for more than 2
seconds.
» The radio tunes to a station
with strong reception reception
automatically.
3
Repeat step 2 to tune to more stations.
• To fine tune a radio frequency, press
briefly / .
Program radio stations manually
1
Tune to a radio station.
2
Display the current radio frequency (press
).
3
Press briefly PROGRAM.
» a number blinks on the display panel.
4
Press / to allocate a number to this
ration station.
5
Press to confirm.
6
Repeat the above steps to program other
stations.
Delete a preset station
1
In radio mode, display a preset number
(press ).
2
Press PROGRAM.
3
Press / to select a preset number.
4
Press to delete the radio station.
» When the radio station is deleted, DEL
is displayed briefly.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz.
1
Press RADIO to switch to radio source.
2
Press and hold to toggle between 50
kHz or 100 kHz.
EN
11