Pioneer TS-SW300254 Instruction Manual

Pioneer
TS-SW300254
TS-SW250254
TS-SW2002D2
CAR-USE COMPONENT SUBWOOFER
Be sure to read this instruction manual before installing this speaker.
LL WARNING
The sealed enclosure series subwoofers are capable of reproducing music at extremely loud levels. Caution should be
exercised to prevent permanent hearing loss. Additionally, driving with the system at high volume levels could impair your ability to
hear emergency vehicles.
CAUTION
• To prevent damage to your speakers please observe the following caution.
• At high volume levels if Iha music sounds distorted or additional sounds era parcaivad lower Iha volume.
• PIONEER recommends that this speaker be used in conjunction with amplifiers whose continuous {RMS) output is lower than the nominal input power of this speaker.
Since this speaker is continuously used being turned on full blast. temperature of Iha magnetic circuit rises, avoid touching ii directly by hand and placing something near it. If it is
•
heated, it may cause a burn, deformation of or damage to peripheral things.
(T -SW3002S4, TS-SW2602S4)
• I this product Is used In free-air conditions (without an enclosure), Insufficient damping causes the sound without accuracy and reduoes the power handling capability to 114 of its
usual levels. It may rasuit in permanent damage to the product.
(TS-SW2002D2)
• Navar connect only one voice coil of this Dual Voice Coil {DVC) speaker.
• B voice coils must be connected to the amplifier for correct operation.
e APPLICABLE FOR FREE AIR USE
l 2002D2)
n y fo r
(O
The TS-SW2002D2 is also capable for FREE AIR use, for applications such as rear
deck mounting in a sedan.
OEM·FIT allows the TS-SW2002D2 shallow subwoofer to fit into many OEM subwoofer location and can be integrated with the OEM amplifier or connected to a more powerful
aflermarket amplifier.
• OEM-frlandly mounting holes flt a wide variety of OEM subwoofer mounting lypas.
• Shallow basket design minimizes the need to modify the OEM subwoofer enclosure.
• Dual 2-0hm voioe coil can be wired to match the impedance of most OEM subwoofers.
* OEM {Orlglnal Equipment Manufacturing) =Factory / equipment