Kenmore 10325 Use & Care Manual page 14

EMPTYING DUST CUP
WARNING
Always unplug power cord from
electrical outlet before performing
any service on vacuum cleaner.
TO REMOVE DUST CUP
1. Lift dust cup handle located at the top
of the dust cup.
Cup
Handle
Cup
2. Pull the dust cup handle up and lift dust
cup up and out of the vacuum cleaner.
3. Remove any
clogs that might
be located in the
suction port or
filter port area.
Port
Port
TO EMPTY DUST CUP
1. Raise dust cup handle to the vertical
position.
'2. Hold dust cup over a trash container.
3. Press the dust
cup latch Cup
downward to Handle
release the door.
The door wilt
swing open and x
the debris will
X
fall into the trash
container.
4. Shake the dust
cup to release Cup
debris that --_ Latch
any
might hang in the
pre-filter.
_ 5. After the dust cup is
empty of debris, firmly
close the door. Make
sure you hear a "click"
sound to indicate that
the door is fully
latched.
TO REINSTALL DUST CUP
1. Place dust cup
back into vacuum
cleaner by inserting
the bottom first and
tilting back with the
dust cup handle
raised.
2. Lower the dust
cup handle to
lock dust cup in
place. A
noticeable
"click" should be
heard.
=14 =