Bkm-61D Sdi/Analog Multi Input Adaptor; Functions; Using The Input And Output Connectors - Sony BKM-61D Operation Manual

BKM-61D SDI/Analog Multi Input Adaptor

The BKM-61D SDI/Analog Multi Input Adaptor is a video
signal input adaptor for Sony BVM-A series color video
monitors. When installed in an input option slot on the rear
panel of the video monitor, it provides input and output
connectors for 4:2:2 component digital, composite digital,
analog composite and Y/C signals for the monitor.

Functions

Decoder for serial digital signals/analog
composite signals
The BKM-61D is equipped with a decoder for component
digital (525/625), composite digital (NTSC/PAL), analog
composite (NTSC/PAL/PAL-M/SECAM) and Y/C
signals.
Input and output connectors for serial
digital signals/analog composite signals
The BKM-61D is equipped with two input and one monitor
output connectors for serial digital signals, as well as three
input and three output connectors for analog signals. You
can input and output Y/C signals using the upper four of the
six connectors for analog signals.

Using the input and output connectors

Configuration of input/output connectors
and signals that may be input
The configuration of the input and output connectors and
the signals that may be input are shown below.
16
BKM-61D SDI/Analog Multi Input Adaptor
Serial digital signals
Serial digital signals
Analog composite signals
Y
Analog composite signals
C
Analog composite signals
Input of serial digital signals
You can input serial digital signals to the connectors 1
and 2. You can select either of the signals to output from
the connector 3 (Monitor output). You do not have to
attach a 75-ohm terminator to the connector 3.
Notes
• Only the format of signals that you specified using the
INPUT CONFIGURATION menu (or the format of the
signals that is last received when AUTO is selected) will
be properly output from the MONITOR OUT connector.
• The signals can be output from the MONITOR OUT
connector only when the power of the monitor is ON. No
signal will be output from the connector when the
monitor is in the standby status.
• The MONITOR OUT signals do not satisfy the ON-
LINE signal specifications.
For details on INPUT CONFIGURATION menu, see "C
Setting the Input Configuration – INPUT
CONFIGURATION Menu" in the Operation Manual for
your monitor.
Input of analog composite signals
You can input analog composite signals to the connectors
4, 6, and 8. You can obtain loop-through output of
these signals from the connectors 5, 7, and 9
respectively. If you do not use loop-through output, attach
75-ohm terminators to the connectors 5, 7, and 9.
Input of Y/C signals
You can input Y signals to the connector 4, and C signals
to the connector 6. You can obtain loop-through output of
these signals from the connectors 5 and 7 respectively.
If you do not use loop-through output, attach 75-ohm
terminators to the connectors 5 and 7.
For details on installation of the BKM-61D in a video
monitor, see "Installing into Video Monitors" (page 23).
Assigning input signals to connectors
After installing the BKM-61D in the video monitor, make
necessary settings for each input channel using the INPUT
CONFIGURATION menu of the monitor. The BKM-61D
may not work properly without the settings.
For details on INPUT CONFIGURATION menu, see "C
Setting the Input Configuration – INPUT
CONFIGURATION Menu" in the Operation Manual for
your monitor.