Table of Contents
Advertisement
Switch on the Flash Function for
the Extension
For older telephone systems, the outside line access code
can be R (= FLASH). Only in this setting can a connection
EN
to the public telephone network be made. With the flash
function switched on, a flash signal is triggered with the R
key.
Notice
Outside Line Access Code is Automati-
cally Dialled
Store telephone numbers in the telephone book
at the beginning using R to automatically estab-
lish a connection to the public telephone net-
work. By pressing the R key, E appears on the
display.
1 Press MENU. RECEPT. SET-UP appears on the
display.
2 Select using [ INSTALLATION .
3 Confirm with o. STATION NAME appears on the
display.
4 Select using [ TEL.LINE SETUP .
5 Confirm with o. LINE TYPE appears on the display.
6 Select using [ PBX FLASH .
7 Confirm with o.
8 Using [ select whether by pressing the R key, a flash
signal should be triggered or not.
9 Confirm with o.
Connecting Additional
Devices
Additional Devices
You can operate additional devices on a telephone line,
such as cordless telephones, answering machines, modems
or charge counters.
Connection to the Device
You can connect additional devices directly to your device.
1 Insert the telephone cable of the additional device into
the EXT socket (RJ-11-connection) at the bottom of
the device.
34
Connection to the Telephone Line
Order of Connections
In order for the fax switch to function, the device must be
first in the series if multiple devices are connected to the
same telephone socket. Follow the correct order.
Connection to the First Telephone Socket
Notice
Connection to the First Telephone
Socket
If you have multiple telephone sockets for the
same telephone line, the device must be con-
nected to the first telephone socket.
Using Additional Telephones
(Easylink)
Easylink
With the Easylink function you can control your device
with additional telephones. To use this function, addi-
tional telephones must be set to the tone dialling mode
(DTMF/MFV tones) (for this purpose see the operating
manual of your additional telephone).
Starting Fax Reception
If you pick up at an additional device and hear that you are
receiving a fax (whistling tone or silence), you can start the
fax reception by pressing ** on the additional tele-
phone.
Changing Code
Changing Easylink Codes!
CAUTION!
Changing Easylink Codes!
Change the code only if it is absolutely neces-
sary. The code must begin with * or # .
1 Press MENU. RECEPT. SET-UP appears on the
display.
2 Select using [ INSTALLATION .
3 Confirm with o. STATION NAME appears on the
display.
4 Select using [ TEL.LINE SETUP .
5 Confirm with o. LINE TYPE appears on the display.
6 Using [ select REMOTE CONTROL .
7 Confirm with o.
8 Using [ select YES .
9 Confirm with o.
10 Enter the new code for starting fax reception.
11 Confirm with o.
12 You can exit with j.
Notice
Switching Off Function
You can switch this function off, if in step 8 you
select NO , confirm using oand exit using j.
Philips · IPF 520 · 525 · 555
Advertisement
Table of Contents
