Chapter 5
Configuring IP Services
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enabling IPv4 Routing
By default, the IPv4 routing feature is disabled in all switches.
To enable the IPv4 routing feature, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# ip routing
Step 3
switch(config)# no ip routing
Verifying the IPv4 Routing Configuration
Use the show ip routing command to verify the IPv4 routing configuration.
switch(config)# show ip routing
ip routing is enabled
IPFC Configuration Example
This section describe an example configuration for IPFC.
The example network has the following links:
•
•
Figure 5-3
IP address: 10.1.1.3
IP subnet: 255.0.0.0
The following steps show how to configure Switch_1 in the example network in
OL-19525-01,Cisco MDS NX-OS Release 4.2(1)
0 packets input, 0 bytes, 0 errors, 0 multicast
0 packets output, 0 bytes, 0 errors, 0 dropped
Switch_1 is connected to the main network by the mgmt 0 interface and to the fabric by an ISL.
Switch_2 and Switch_3 are connected to the fabric by an ISL but are not connected to the main
network.
IPFC Example Network
Switch_3
Purpose
Enters configuration mode.
Enables IPv4 routing (disabled by default).
Disables IPv4 routing and reverts to the factory settings.
Figure 5-3
Switch_1
IP address: 10.1.1.1
IP subnet: 255.0.0.0
Switch_2
Cisco MDS 9000 Family NX-OS IP Services Configuration Guide
shows an example network.
IP address: 10.1.1.2
IP subnet: 255.0.0.0
Figure
5-3:
IPFC
5-7