Connecting Computer And Projector; Checking The Projector - Panasonic ET-UW100 Operating Manual

Connecting Computer and Projector

Verify the network ID and other information for the projector, and then perform connection of the projector .

■ Checking the projector

1 . Powering up the projector
Turn on the power of the projector .
2 . Setting the input
Press the <Panasonic APP> button / <NETWORK> button on the remote control (or press the <INPUT SE-
LECT> button on the projector), and switch the input to [Panasonic APPLICATION] or [NETWORK].
A standby screen is displayed in the image projected by the projector.
3 . Checking the projector
Check the projector's wireless LAN connection setting, projector name, and network ID.
The locations where this information is displayed may vary depending on the projector .
z For projectors that display the standby screen (Projector image)
The standby screen may not appear even for projectors that display that screen if
another user is already projecting an image or if the multi live mode (Page 15) is be-
ing used in the 4-screen or 16-screen index style . In such cases, you can check the
network ID by pressing the AUTOSETUP button.
・Example of standby screen display.
Projector name
connecton setting
z For projectors that do not display the standby screen (Projector image)
・ Example of input guidance display .
Network ID
Wireless LAN
Projector name
INPUT
SIGNAL NAME
MEMORY NO
WIRELESS LAN
PROJECTOR NAME
NETWORK ID
Wireless LAN
connecton setting
Network ID
NETWORK
Wireless LAN
XGA-A1
connecton setting
A1
S-DIRECT
Projector name
NAME1234
Proj1234
Network ID
– 7 –