Advertisement
H) Put the cartridge down on your work surface or bench, and insert a Rivet into the
exit port you just filled. Don't turn the cartridge upside down. Make sure the Rivet
is all the way in, so the head is touching the cartridge. Use a paper towel and wipe
any excess ink off the bottom of the cartridge. The Rivet will prevent leakage and
cross contamination from other inks.
I)
Now go to the next color and repeat this process until all 4 of the chambers are full.
Take the filled cartridges and tubing to a place near your printer and set them on a
flat surface. Put a pencil or some sheets of paper under the end of the cartridge so
that it is perfectly level. Make sure the end of the tubes are open and not kinked or
twisted.
You are done for today. Let the freshly filled cartridges age overnight. You can
continue in the morning or later in the day with the next step in the process. This is
important, don't try to rush it. The ink needs about 8 hours to get fully absorbed by
the sponge. Any bubbles or gases will come to the surface and disappear.
2. Establish Working Condition of Printer- Make sure nozzle check is perfect
With an image on your screen and paper in the printer, click on file | print, then on
printer properties. When you see the Utility tab on the printer properties dialog
box, click on it, then on Nozzle check. This can also be done from the Control Panel
| Printers section by right clicking on the correct printer and then clicking on
properties.
S a v e
M o n e y
MIS Associates Inc
http://www.inksupply.com
a n d
I m p r o v e
2901 Auburn Rd
Fax: 248-289-6013
Y o u r
Auburn Hills, MI 48326
Email: sales@inksupply.com
P r i n t i n g
800-445-8296
Advertisement
