Unit Withdrawal And Insertion - GE 339 Instruction Manual

CHAPTER 2: INSTALLATION

Unit withdrawal and insertion

NOTE: IT IS THE RESPONSIBILITY OF THE USER TO ENSURE THAT THE EQUIPMENT IS INSTALLED, OPERATED, AND USED FOR ITS
INTENDED FUNCTION, IN THE MANNER SPECIFIED BY THE MANUFACTURER. IF THIS IS NOT THE CASE, THEN THE SAFETY PROTECTION
PROVIDED BY THE EQUIPMENT MAY BE IMPAIRED.
339 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
Figure 9: Unit withdrawal and insertion diagram
STEP 2
KEEP THE HANDLE IN ITS ROTATED
POSITION UNTIL THE DRAW-OUT UNIT
IS INSERTED COMPLETELY
THE HANDLE MUST BE ROTATED 90
WHILE SLIDING THE 339 DRAW-OUT
UNIT INTO THE CAPTIVE UNIT
STEP 3
MECHANICAL INSTALLATION
STEP 1
⁰
PUSH THE HANDLE DOWN AND TIGHTEN
THE SCREW UNTIL THE HANDLE IS PARALLEL
WITH THE FRONT PANEL SURFACE
2–7