Attaching the Access Point to the Mounting Plate
Attaching the Access Point to the Mounting Plate
Follow these steps to attach the access point to the mounting plate:
Open the access point cover (see the
Step 1
In the cable bay area, pull the cables through one of the access point cable openings (see
Step 2
In the cable bay area, line up the visible access point keyhole with the mounting plate keyhole clip
Step 3
located near the security padlock hole (see
Figure 2-12 Aligning the Keyhole Clip to the Access Point Keyhole
1
2
3
Insert the keyhole clip into the keyhole and maintain a slight pressure to hold the access point in place.
Step 4
Slightly rotate the access point from side-to-side until you hear the second keyhole clip falling into the
Step 5
other keyhole (not visible).
Slide the access point back over the keyhole clips. You will hear a click when the locking detent contacts
Step 6
the access point and locks it into place.
For instructions on connecting your cables, refer to the
section on page
Cisco Aironet 1130AG Series Access Point Hardware Installation Guide
2-16
C I S C O C O N F I D E N T I A L -
Access point keyhole
Mounting plate keyhole clip
Mounting plate
2-17.
D r a f t 2
"Opening the Access Point Cover" section on page
Figure
2-12).
4
Security screw hole
5
Padlock hole
"Connecting the Ethernet and Power Cables"
Chapter 2
Installing the Access Point
2-8).
Figure
OL-6226-01
2-6).