Common Port Mappings - Dell Edge 5000 Series Installation And Operation Manual

Hide thumbs Also See for Edge 5000 Series:
Table of Contents

Advertisement

Watchdog Timer
The Watchdog Timer for Windows 10 IoT Enterprise LTSB 2015 is controlled via the BIOS setting. Enter the BIOS during boot by
pressing F2. The Watchdog Timer is enabled and disabled under the BIOS setting Watchdog Timer.
TPM Support
Windows 10 IoT Enterprise LTSB 2015 supports TPM 2.0. Access the following link for TPM resources:
technet.microsoft.com/en-us/library/cc749022(v=ws.10).aspx
System Shutdown and Restart
Click the Start Icon and then press Power then Restart or Shutdown the Edge Gateway.
LAN/WLAN Network configuration
Click the Start Icon and then type Settings and open the Settings window. Select Network & Internet from the settings menu.
Bluetooth configuration
Click the Start Icon and then type Settings and open the Settings window. Select Devices from the settings menu and then select
Bluetooth from the menu on the left panel.
LE910 Network configuration
Follow the Service Manual to install and configure the WWAN module and the corresponding carrier SIM card for the system. After
the WWAN module and the SIM cards are installed:
1.
Click the Start Icon and then type Settings and open the Settings window.
2.
Select Network & Internet from the Settings Menu.
3.
Locate the WWAN connection in the Wi-Fi section and select the entry to connect and disconnect from the WWAN adapter.
HE910 Network configuration
Follow the Service Manual to install and configure the WWAN module and the corresponding carrier SIM card for the system. After
the WWAN module and the SIM cards are installed:
1.
Click the Start Icon and then type Settings and open the Settings window.
2.
Select Network & Internet from the Settings Menu.
3.
Locate the WWAN connection in the Wi-Fi section and select the entry to connect and disconnect from the WWAN adapter.

Common port mappings

Serial Port Mapping
The table show the serial port mapping on the Edge Gateway 5000/5100 with factory installed Windows 10 IoT Enterprise LTSB
2015. For dip switch setting on the Edge Gateway for RS422 and RS485 ports, see
No.
Port Type
1
RS232
2
RS422_485
3
RS485
4
RS485
Connector
DB9
5 pin terminal
3 pin terminal
3 pin terminal
https://
DIP
Switches.
Device Node
COM1
COM2
COM3
COM4
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Edge 5100 series

Table of Contents