Table of Contents
Advertisement
4-1
StreamIOm G1.0/LinX
Internet A/V Module
This module is not intended to be repaired on component level.
Circuit Diagrams and Printed Circuit Board drawings
are published for orientation only.
In case of defects please replace the entire module.
Modules can be ordered with codenumber "3103 308 67790".
Internet A/V Module – Service Hints
The Internet A/V Module StreamIOm G1.0/LinX is not
intended to be repaired on component level. Only the
complete Printed Board Assembly and the Wireless LAN
Card are available as service spare part. These articles can
be ordered with the following codenumbers:
StreamIOm G1.0/LinX PBAS .......3103 308 67790
Wireless LAN Card.......................9307 008 01371
Important note: When replacing the Internet A/V
Module the set 12NC must be programmed into the
module before returning the set to the customer !!
The 12NC depends on the stroke version of the set and
can only be programmed with the help of an external
application – the so-called Factory Test Server.
Factory Test Server Application
The Factory Test Server serves two purposes:
1. To test the Internet streaming of the module, without
having a broadband Internet connection present.
2. To program the SET 12NC into the module after
replacement.
The Factory Test Server Application is available at
dedicated workshops, only.
Basic requirements:
• PC running Windows NT4 Service Pack 6 or higher,
Windows 2000, or Windows XP Pro
• 400MB hard disk space
• Ethernet network card
• Ethernet crossover cable or Ethernet hub with standard
patch cable
• Wireless Access Point
• Mouse
• Monitor
• CD-ROM drive (for installation)
For detailed instructions on how to install, setup and use
this application please refer to the "Factory Test Server
Application Manual", included on the CD-ROM.
4-1
Advertisement
Table of Contents
