Connecting Cable Tv Systems To The Tv/Vcr; Cable Without A Converter Box; Cable With A Converter Box - Toshiba M-V19H01 Service Manual

I
NSTALLATION
Connecting VHF and UHF
Antennas, continued
The supplied antenna has 300-
ohm twin flat leads. If you use a
different 300-ohm antenna with
twin flat leads, follow the direc-
tions below, but skip step 1.
Œ
Push the stem of the rod
antenna into the antenna
mount.
´
Connect both antenna leads
to the combiner.
3-6 3-6 C T : I
HAPTER WO NSTALLATION
ˇ
Plug the combiner into the
terminal on the rear panel of
the TV/VCR.
Connecting Cable TV
Systems to the TV/VCR
Choose one of the sections below
for connecting a cable system.
This TV/VCR is cable-ready; you
don't need a converter for basic
cable channels.
Cable Without a
Converter Box
To connect cable without a
converter box:
Œ
Plug the incoming cable into
the terminal on the rear panel
of the TV/VCR.
Cable With a
Converter Box
If your cable company
scrambles some channels and
requires you to use a converter
box for only those channels, use
these instructions.
You will need the following
pieces of equipment, which you
can purchase from an
electronics store:
• A two-way splitter
• An RF (A/B) switch
• Four lengths of coaxial cable
Œ
Plug the incoming cable into
the 2-way splitter.