Panasonic AU-V35LT1G Operating Instructions Manual page 28

Power supply
@ NOTE
t When both the battery and the external DC power supply are connected, the power supply from the
external DC power supply has priority. The battery may be removed while using the external DC power
supply.
t When using the external DC power supply, always turn on the power switch of the external DC power
supply before setting the power switch of the camera to <l>. If the operations are performed in reverse,
the camera may malfunction because the external DC power supply output voltage rises too slowly.
t When switching the power supply from an external DC power supply to the battery, carefully remove the
DC cable from the <DC IN> terminal. Removing the cable quickly may temporarily stop the camera's
operation.
t When power is supplied from the <DC IN> terminal, the light circuit does not function. The light circuit
can be used only when power is supplied from the Anton/Bauer battery plate.
t When connecting a battery to the <DC IN> terminal, set [MENU] → [SYSTEM SETTINGS] → [POWER
MANAGEMENT] → [DC IN SOURCE] to [BATTERY], then set [- FULL VOLT], [- NEAR END VOLT], or [-
END VOLT] to match the characteristics of the battery. However, in this the case, the percent (%) display
will not be available for batteries with a battery level indicator function.
28
DC IN
1
2
3
4
Panasonic Parts No.: K1AA104H0038
Manufacturer Parts No.: HA16RX-4P (SW1) (76) (Hirose Electric
GND
NC
NC
+12 V
Co.)