Page 1
http://www.xiaoyu163.com WM-EX610 3 7 63 1515 0 SERVICE MANUAL AEP Model UK Model Ver 1.0 2000.10 Chinese Model Tourist Model Manufactured under license from Dolby Laboratories Model Name Using Similar Mechanism Licensing Corporation. Tape Transport Mechanism Type MT-WMEX610-162 “DOLBY” and the double-D symbol a are trademarks of Dolby Laboratories Licensing Corporation.
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE circuit board (within 3 times). COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS • Be careful not to apply force on the conductor when soldering APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS or unsoldering.
http://www.xiaoyu163.com SECTION 1 SERVICE NOTE 3 7 63 1515 0 [Service Mode] The service mode enables to operate the mechanism of WM-EX610 3. FF, REW modes while the MAIN board is opened. Check that the PRE-SET status is set. Rotation of the idler gear (A) (S side) is detected using the photo- Connect square wave or sine wave to TP53 (P.
Page 4
http://www.xiaoyu163.com 3 7 63 1515 0 [ Slider (NR) ] [ Tape drive mechanism ] Tape drive mechanism in PLAY mode Gear (NR) (FWD : Left side REV : Right side) Idler Gear Idler Gear (A)(S side) Slider (NR) (A)(T side) Gear Gear (REEL)(S side) (REEL)(T side)
http://www.xiaoyu163.com SECTION 2 This section is extracted from instruction manual. GENERAL 3 7 63 1515 0 EX615 BATT UK, Australian, and Other models Hong Kong model EX610 BATT L 13942296513 Plug in firmly. REW (–) FF (+) SOUND HOLD MODE Y•x HOLD HOLD...
To stop a single repeat, press it • For maximum performance we recommend that you • You cannot turn on/off the Dolby B NR function use a Sony alkaline battery. again. during fast-forward or rewind. Rechargeable Battery * If Y•x on the remote control is pressed during fast...
http://www.xiaoyu163.com SECTION 3 DISASSEMBLY 3 7 63 1515 0 Note : Follow the disassembly procedure as shown in the flow chart below. Case sub Motor (M901) Main board Belt (F4) assy Head, magnetic Ornament, Lever (NA)/(RA) Lid assy, Holder (FS) (HP901) reel assy, pinch...
http://www.xiaoyu163.com 3 7 63 1515 0 3-2. MAIN BOARD 2 Remove soldering (four points) from the leaf switch. 5 Two Screws (M2.0) 3 Remove soldering (two points) S701 from plunger solenoid. 1 Remove soldering (six points) from the head flexible boards. 7 MAIN board Note : Be careful of the claw.
http://www.xiaoyu163.com 3 7 63 1515 0 3-6. ORNAMENT, REEL 1 Ornament, reel Claw Note : Remove the assembly while removing the 5 claws and the boss carefully. Claw Boss Claw Claw Claw L 13942296513 3-7. HOLDER (FS) ASSY 2 Shaft 7 Bracket (cassette) assy 5 Lock Lever (S) 3 Lock Lever (B)
http://www.xiaoyu163.com 3 7 63 1515 0 3-8. LEVER (NA)/(RA) ASSY, PINCH Claw 1 Remove the pinch lever (RA) assembly in the direction of the arrow. Note : Be careful of the claw. 2 Remove the pinch lever (NA) assembly in the direction of the arrow. Note : Be careful of the claw.
http://www.xiaoyu163.com SECTION 4 SECTION 5 MECHANICAL ADJUSTMENT ELECTRICAL ADJUSTMENT 3 7 63 1515 0 PRECAUTION PRECAUTION Clean the following parts with a denatured-alcohol-moistened Specified voltage: 1.3 V (DC) swab: Switch position (MENU) playback head pinch roller : OFF rubber belts capstan AVLS : OFF...
http://www.xiaoyu163.com WM-EX610 3 7 63 1515 0 6-2. IC BLOCK DIAGRAMS IC301 TA2123AF (EL) 36 35 – RF IN PW GND – OUT B PW B OUT C C-AMP SW 37 MT TC PW A PW C OUT A – BEEP 39 BEEP AMS OUT 40...
http://www.xiaoyu163.com WM-EX610 3 7 6 3 1 5 1 5 0 6-4. SCHEMATIC DIAGRAM Note on Schematic Diagram: • All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. •...
http://www.xiaoyu163.com 3 7 63 1515 0 6-5. IC PIN FUNCTION • MAIN BOARD IC701 ML63512-127TBZ060 (SYSTEM CONTROL) Pin No. Pin Name Description N.C. – Not used FWD SW Detection switch (S701) input terminal “L”: FWD CENTER SW Detection switch (S701) input terminal “L”: CENTER Detection switch (S701) input terminal “L”: REV REV SW Cassette detection switch (S901-1) input terminal...
Page 18
http://www.xiaoyu163.com 3 7 63 1515 0 Pin No. Pin Name Description AMS IN AMS detection signal input from TA2123F (IC301) “H”: No music LED AVLS Drive signal output for AVLS display Not used in this machine (empty terminal) LED BLSKIP Drive signal output for BL SKIP display Not used in this machine (empty terminal) LED MB Drive signal output for MG GRV display Not used in this machine (empty terminal)
http://www.xiaoyu163.com SECTION 7 EXPLODED VIEWS 3 7 63 1515 0 NOTE: • -XX, -X mean standardized parts, so they may • Color Indication of Appearance Parts Example: When indicating parts by reference number, have some differences from the original one. KNOB, BALANCE (WHITE) .
http://www.xiaoyu163.com SECTION 8 MAIN ELECTRICAL PARTS LIST 3 7 63 1515 0 NOTE: • Due to standardization, replacements in the • CAPACITORS: When indicating parts by reference number, parts list may be different from the parts uF: µF please include the board name. specified in the diagrams or the components •...
Page 22
http://www.xiaoyu163.com MAIN 3 7 63 1515 0 Ref. No. Part No. Description Remarks Ref. No. Part No. Description Remarks < JACK > R209 1-216-821-11 METAL CHIP 1/16W R210 1-216-837-11 METAL CHIP 1/16W J301 1-779-867-11 JACK (REMOTE) R211 1-216-825-11 METAL CHIP 2.2K 1/16W R212...